24 Vdc max. 40 A 12 Ah UPS-Control Software Visualization and configuration software for the charging and control unit.Free download at www.block.eu. For the display and individual setting of the loading and control unit. BLOCK Transformatoren-Elektronik GmbH Max-Planck-Straße 36-46 10.06.2024 / FRA...
In the event of malfunctions or damage, immediately switch off the supply voltage and send the device to BLOCK Transformatoren-Elektronik GmbH for inspection. The device does not include any service components. If an internal fuse is tripped, there is most likely an internal defect in the device.
Page 5
Do not operate the appliance in a humid environment or in an environment where condensation or condensation. ATTENTION Do not touch the housing during operation or shortly after shutting down. Hot surfaces can cause injuries. BLOCK Transformatoren-Elektronik GmbH Max-Planck-Straße 36-46 10.06.2024 / FRA Phone +49 4231 678-0 Fax +49 4231 678-177 •...
Depending on the application, either up to 20A or up to 40A are available without interruption with 24V networks. The UPS always ensures a secure supply of industrial PCs. Figure 1: Battery Modules PST-0124-032-00 / PST-0124-070-00 BLOCK Transformatoren-Elektronik GmbH Max-Planck-Straße 36-46 10.06.2024 / FRA...
V 1.1 PST-BATTERYMODUL Block diagram The following block diagram shows a wiring example. To ensure good communication between the battery modules and the charging and control unit, interface, control and signal cables < 3 meters must be selected. In addition, care must be taken not to lay the control cable parallel to power lines, otherwise disturbances in communication are to be expected.
V 1.1 PST-BATTERYMODUL Dimensioning The dimensions of the loading and control unit can be seen in Figure 3. Figure 2: Dimensions of the battery modules BLOCK Transformatoren-Elektronik GmbH Max-Planck-Straße 36-46 10.06.2024 / FRA Phone +49 4231 678-0 Fax +49 4231 678-177 •...
Abbildung 3: Montage ATTENTION Mounting the battery modules overhead is not permitted. ATTENTION Mount the device horizontally only. A different assembly is not permitted. BLOCK Transformatoren-Elektronik GmbH Max-Planck-Straße 36-46 10.06.2024 / FRA Phone +49 4231 678-0 Fax +49 4231 678-177 •...
The temperature compensation for battery modules without "Battery Control" is treated as in the case of a communication interruption. Depending on the UPS used, changes can only be made via the UPS Control software or via the front potentiometers. BLOCK Transformatoren-Elektronik GmbH Max-Planck-Straße 36-46 10.06.2024 / FRA...
The buffer time can be extended by up to three battery modules connected in parallel. It should be noted that only the same battery modules with the same state of charge may be connected. BLOCK Transformatoren-Elektronik GmbH Max-Planck-Straße 36-46 10.06.2024 / FRA...
Battery module life The battery modules of the PST series are equipped with sealed, maintenance-free lead fleece batteries that are designed for -10 °C to +40 °C. The service life of these battery modules is between 5 years at 20 °C and one year at 40 °C, depending on the ambient temperature.
Need help?
Do you have a question about the PST Series and is the answer not in the manual?
Questions and answers