Setting The Fabric In The Embroidery Frame - Brother PE-180D User Manual

Setting the fabric in the embroidery frame

20
1. Make a mark on the fabric with chalk or marking pencil
indicating the center of the area to be embroidered.
2. Loosen the adjusting screw of the outer frame, place the
fabric on top of the outer frame with the right side of the
fabric up, and then place the inner frame into the outer
frame to clamp the fabric.
* Make sure that the
are aligned.
1 Fabric
2 Right side surface for embroidering
3 Adjusting screw
4 Inner frame
5 Outer frame
6 Loosen
3. Firmly tighten the adjusting screw, and then temporarily
remove the fabric and the inner frame from the outer frame.
1 Tighten
4. Place the embroidery sheet on top of the inner frame so that
the center crosshairs on the embroidery sheet and the mark
on the fabric are aligned.
1 Inner frame
2 Vertical + horizontal crosshair lines
1 Area available for embroidering
2 Vertical + horizontal crosshair lines
3 Center of the crosshairs and the pattern
marks of the outer and inner frames