Brother HL-3070CW Quick Setup Manual page 27

Wireless Network
Note
• If you want to setup or configure additional
WEP key indexes other than WEP key1, click
Advanced.
• If you do not know the Authentication or
Encryption settings for your network, contact
your network administrator or the manufacture
of your access point/router.
• If you are using WEP and the printed Network
Configuration page in n shows Link OK in the
Wireless Link Status, but the printer is not
found on your network, make sure you entered
the WEP key correctly. The WEP key is case
sensitive.
n
Click Next. The settings will be sent to your
printer. The settings will remain unchanged if
you click Cancel. The Network Configuration
page will be printed.
Note
• If you want to manually enter the IP Address
settings of your printer, click
Change IP Address and enter the necessary
IP Address settings for your network.
• The control panel settings will be automatically
changed to WLAN Enable when the wireless
settings are sent to your printer.
o
Check the printed Network Configuration page.
Choose the status as it is shown for the
Wireless Link Status on the Network
Configuration page. Click Next.
If your status is Link OK, go to q.
If your status is Failed to Associate, go to p.
p
Click Finish. Wireless setup was unable to
associate with a wireless network. This is
probably due to incorrect security settings.
Reset the print server back to its factory default
settings (see page 44). Confirm the security
settings of your wireless network that you wrote
down on page 24 and try starting from d on
page 25 again.
q
Disconnect the network cable between your
access point (hub or router) and the printer,
and click Next.
®
Windows
27