Brother HL-3070CW Quick Setup Manual page 26

Wireless Network
j
Choose the printer you wish to configure, and
click Next. If the list is blank, check if the
access point and the printer are powered on,
and then click Refresh.
Note
• The default Node name is "BRNxxxxxxxxxxxx".
• You can find your printer's MAC Address
(Ethernet Address) and the IP Address by
printing out the Printer Settings Page. See Print
the Printer Settings Page on page 44.
k
The wizard will search for wireless networks
available from your printer. Choose the access
point you wish to associate the printer with
(The SSID you wrote down on page 24), and
then click Next.
26
Note
• SETUP is the default SSID of the printer. Do
not choose this SSID.
• If the list is blank, check that the access point
has power and is broadcasting the SSID, and
then see if the printer and the access point are
within range for wireless communication. Then,
click Refresh.
• If your access point is set to not broadcast the
SSID you can manually add it by clicking the
Add button. Follow the on-screen instructions
for entering the Name (SSID), and then click
Next.
l
If your network is not configured for
Authentication and Encryption, the following
screen will appear. To continue configuration,
click OK and go to n.
m
If your network is configured for Authentication
and Encryption, the following screen will
appear. When configuring your Brother
wireless printer, you must configure your
printer to match the Authentication and
Encryption settings you wrote down on
page 24 for your existing wireless network.
Choose the Authentication Method and
Encryption Mode from the pull-downs in each
setting box. Then enter the Network key and
Confirm Network Key, and then click Next.
®
Windows