Terex Genie SX-125 XC Installation Instructions
Length transducer replacement
Hide thumbs
Also See for Genie SX-125 XC:
- Service and repair manual (319 pages) ,
- Maintenance manual (198 pages) ,
- Operator's manual (76 pages)
Related Manuals for Terex Genie SX-125 XC
Summary of Contents for Terex Genie SX-125 XC
- Page 1 Installation Instructions Length Transducer Replacement -125 XC ™ ™ Original Instructions First Edition First Printing Part No. 1327482GT February 2024...
-
Page 2: Observe And Obey
Genie models listed on the front cover. Copyright © 2024 by Terex Corporation First Edition: First Printing, February 2024 Genie is a registered trademark of Terex South Dakota, Inc. in the U.S.A. and many other countries. "SX" and "XC" are trademarks of Terex South Dakota, Inc. -
Page 3: Tools Required
First Edition • First Printing Instructions Introduction Tools Required: Components of Kit 1327483GT 3/8 inch wrench Description Genie part Qty. number 7/16 inch wrench Flange screw, HHF, 1/4-20 x .75, 824078GT 8, ZAG 3/8 inch socket Nylock flange nut, 1/4-20, F, ZAG 1277924GT 7/16 inch socket Length transducer, 800 in... - Page 4 Instructions First Edition • First Printing Procedure Proc edure Note: Perform this procedure on a firm, level Pull the transducer assembly away from the surface with the machine in the stowed position. mast assembly and disconnect the transducer cable. Discard the transducer assemby. Turn the key switch to the off position and push in the red Emergency Stop button to the Secure the length transducer to the string pot...
- Page 5 First Edition • First Printing Instructions Procedure Secure the transducer assembly to the mast assembly using the retaining fasteners set aside. 1 transducer assembly 2 retaining fasteners 10 Connect the length transducer harness to the machine. 11 Install the mast cover using the retaining fasteners set aside.
Need help?
Do you have a question about the Genie SX-125 XC and is the answer not in the manual?
Questions and answers