LCD DISPLAY 2. Clean only with dry cloth. 3. Do not install near any heat sources such as A. Radio alarm radiators, heat registers, stoves, or other apparatus B. Buzzer alarm (including amplifiers) that produce heat. B. Stereo symbol 4. Only use attachments/accessories specified by the D.
Page 6
● Replace only with the same or equivalent type. SPECIFIC SAFETY RULES ● Only use genuine Makita batteries. Use of non- FOR BATTERY CARTRIDGE genuine Makita batteries, or batteries that have been altered, may result in the battery bursting 1.
OPERATING TIME * The suitable battery packs for this radio listed as the following table. * The following table indicates the operating time on a single charge. AT SPEAKERS OUTPUT = 100mW Battery cartridge voltage Unit: Hour (Approximately) Battery capacity 10.8V –...
INSTALLATION AND POWER Indicating the remaining battery capacity SUPPLY * Only for battery cartridges with “B” at the end of the model number. CAUTION: ● Be careful not to pinch your fingers when opening and closing the battery cover. ● Return the battery compartment locker to the original position, after installing or removing battery cartridge.
● Use the AC power adaptor supplied with the product or specified by Makita only. LISTENING TO THE RADIO ● Do not hold the power supply cable and plug by your mouth.
Display modes – FM 4. After a few seconds the display will update. The display will show the frequency of the signal found. Your radio has a range of display options for FM radio 5. To find other station, press and hold the Tuning control mode.
MISCELLANEOUS SETTINGS Radio Data System (RDS) When you set the clock time using the RDS function, your Setting the time and date format radio will synchronize its clock time whenever it tunes to a radio station using RDS with CT signals. The clock display used in stand-by mode and on the 1.
Sleep timer Note: ● If new radio alarm station is not selected, it will select Your radio can be set to turn off automatically after a the last alarm station. preset time has elapsed. The Sleep Timer setting can be ●...
4. Rotate the Tuning control knob to select your required device again to the radio. middle level. Press the Tuning control knob to enter the ● If ‘DMR114’ shows in your Bluetooth device list but your “TREBLE” setting. device cannot connect with it, please delete the item 5.
SPECIFICATIONS Playing a previously-paired Bluetooth source device Power requirements If your Bluetooth device already paired with the radio DC 12V 2.5A, center pin previously, the unit will memorize your Bluetooth device AC power adaptor positive and it attempts to reconnect with a device in memory which is last connected.
Need help?
Do you have a question about the DMR114 and is the answer not in the manual?
Questions and answers