Lomography LOMO'INSTANT SQUARE Manual page 18

Remote Control
The remote control included with the Lomo'Instant Square works via infrared
transmission. Simply remove the Remote Control Unit
shoot from afar.
There are two buttons on the Remote Control Unit
Bulb Mode. To use the remote shutter release function, point the Infrared Transmitter
of the Remote Control Unit
Control Back Receiver
mode:
INSTANT Button
RC3
for normal shutter release.
RC4
TIME Button
shutter for exposure, then press the button once more to close the camera shutter. The
maximum shutter speed in Bulb Mode is 30 seconds. If you want to expose for longer than
30 seconds, you may use the multiple exposure function to expose the same film multiple
times to accumulate exposure time. (For more on multiple exposures, please see the
chapter above.)
To change the batteries of the Remote Control Unit
Control Battery Cover
CR2025 battery (3 V) and close the Remote Control Battery Cover
RC1
towards the Remote Control Front Receiver
29
and press the button that corresponds to your desired shooting
RC3
: in Auto Mode, press the INSTANT Button
: in Bulb Mode, press the TIME Button
RC5
at the bottom of the Remote Control Unit
RC1
from the camera side bottom to
RC1
: one for Auto Mode and one for
RC4
once to open the camera
RC1
, simply slide open the Remote
RC1
RC5
.
RC2
28
or Remote
. Then, install one
18