Advertisement
The tests do not start straight away but within a period of 36 seconds when
using the standard settings. The test time start depends on the settings of the
detector scanning period (the paragraph on "Jeweller" in hub settings).
You can test the Jeweller signal strength between the range extender and the
hub, as well as between the range extender and the device connected to it.
To check the Jeweller signal strength between the range extender and the hub,
go to the ReX settings and select Jeweller Signal Strength Test.
To check the Jeweller signal strength between the range extender and device, go
to the settings of the device connected to ReX, and select Jeweller Signal
Strength Test.
Jeweller Signal Strength Test
Device installation
Selection of the installation site
The location of ReX determines its distance from the hub, the devices
connected to the extender, and the presence of obstacles preventing the
passage of the radio signal: walls, interfloor bridgings, and large objects located
in the facility.
The device developed only for indoor use.
Check the signal strength at the installation site!
If the signal strength reaches just one bar on the indicator, the stable operation
of the security system can not be guaranteed. Take whatever action is
necessary to improve the quality of the signal! At the very least, move ReX or
hub — relocation even by 20 cm can significantly improve the reception quality.
Advertisement
Need help?
Do you have a question about the ReX and is the answer not in the manual?