Electrolux EW2F3048E2 User Manual page 22

12.4 Setting a programme
1. Turn the programme knob and set the
programme:
• The indicator
• The display shows the level of the
Time Manager, the programme
duration and the indicators of the
phases of the programme.
2. If necessary, change the temperature and
the spin speed or add available options.
When you activate an option, the
indicator of the set option comes on.
If you set something incorrect, the display
shows the message
12.5 Starting a programme without
the delay start
Press .
• The indicator of
stays on.
• The indicator
display.
• The programme starts, the door locks,
the display shows the indicator
• The drain pump can operate for a
short time when the appliance fills
water.
After approximately 15 minutes from the
start of the programme:
• The appliance adjusts automatically
the programme duration agree with
the laundry load.
• The display shows the new value.
12.6 Starting a programme with the
delay start
1. Press Delay Start again and again until
the display shows the delay you want to
set.
The related indicator comes on the display.
2. Press :
• The appliance starts the countdown.
• The door locks, the display shows the
indicator
22 ENGLISH
flashes.
.
stops to flash and
starts to flash on the
.
• When the countdown is completed,
the programme starts automatically.
You can cancel or change the set of the
delay start before you press the
cancel the delay start:
• Press
pause.
• Press Delay Start until the display
shows
• Press
programme immediately.
12.7 The AutoSense System load
detection
The programme duration in the display is
referred to a medium/high load.
After touching the Start/Pause
AutoSense System starts the laundry load
detection:
1. The appliance detects the load in the first
30 seconds. In the programmes where
.
Time Manager is available, during this
phase dot separating hours from minutes
is blinking and the drum rotates shortly.
2. The programme duration could be
adjusted accordingly and could increase
or decrease. After further 30 seconds, the
water filling starts.
About 20 minutes after the programme
start, the programme duration could be
adjusted again depending on the
capacity of water absorption of the
fabrics.
The AutoSense detection is carried out
with complete washing programmes only
and if the programme duration has not
been reduced.
. To
to set the appliance to
'.
again to start the
button, the