Motorola I315 - SOUTHERNLINC Manual page 33

Making and Receiving Code Calls in
LINCaround
To make a code call in LINCaround:
1 Press and hold the PTT button. LA Transmit
appears on the first line of display. Begin
speaking after your phone emits the LINCaround
tone.
2 Release the PTT button to listen.
The tone emitted from your phone when using
LINCaround is 4 beeps and sounds different from
the standard tone heard with on-network Private
and group calls.
If you receive an error message:
• There may be no parties on your channel or
code.
• You are out of range.
When you receive a code call using LINCaround,
LA Receive appears on the first line of the display.
Receive All
You can set your phone to receive LINCaround
transmissions from any phone that is set to the
same channel, regardless of the code (1-15), by
setting the code to Receive All. When you receive
transmissions with the code set to Receive All, the
display changes from Receive All to the code on
which the transmission was received.
Tip: You can reply to an incoming call within 6
seconds after hearing the short ending
beep by pressing the PTT button.
Note: You cannot initiate a code call when the
code is set to Receive All. If you press
the PTT button with the code set to
Receive All, you will receive an error
message.
To set the code to Receive All:
1 From the LINCaround idle screen, press A
under Edit.
2 Scroll to Code.
3 Press A under Edit.
4 Select Receive All.
5 When you are finished, press A under Back to
return to the LINCaround idle screen.
Channels and Codes
23