Page 4
See- 47-CFR-Sec.-15.21. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including...
The indicator light turns red or yellow when the battery is charging. It may take up to 1 minute for the indicator light to turn on. When the headset’s battery is fully charged (about 2 hours), the indicator light turns green.
Therefore, we recommend trying all the supplied earbuds with your headset. You can wear your H620 headset on your left or right ear. The headset comes ready for the right ear. See figure 4 on page 2 Placing the headset on your right ear : See figure 5 on page 2...
English Pairing your headset Your phone’s Bluetooth feature is off by default. To use your headset, turn on the Bluetooth feature in your phone. Please check your phone’s user’s guide. Note : The Bluetooth feature remains on until you turn the feature off.
Your phone and headset are now paired and ready to make and receive calls. To confirm they are successfully paired and operating properly, place the headset over your ear and make a call from your phone. You will hear ringing from the headset.
Page 9
English Using your headset: making & receiving calls Your headset supports both Hands-free and Headset Profiles. Accessing call functions depends upon which profile your phone supports. See your phone’s user’s guide for more information. Note: Some features are phone/network dependent.
Indicator lights Checking battery level While your headset is turned on and not on a call, you can check the battery charge level by pressing and holding both Volume buttons. The indicator light displays charge status for 5 seconds. The colour of the light indicates the remaining talk time.
Page 11
Idle (not connected to phone) Slow purple pulse Connected call muted Steady red Attempting to connect Quick red flash Low battery Note: After 20 minutes on a call or of inactivity, the light stops flashing to conserve power, but the headset remains on.
Headset Status Ascending tone Powering on 2 descending tones Powering off Ring tone Incoming call 2 short tones when pressing Volume at minimum or maximum Volume button High/low tones repeated Low battery every 60 sec. No audio indications; Out of range...
Make sure that any devices previously paired with the headset are turned off. If the indicator light is not steadily lit in blue, turn off both the other device and headset, wait 10 seconds, then turn headset back on. Wait for the indicator light to become steadily lit in blue, indicating the headset is now in pairing mode.