Avigilon OP-16EM Quick Start Manual

Elevator Board Quick Start Guide
OP-16EM
What's Included
Elevator Board Mounting standoffs Screws and washers
Power cable USB cable
Board Status LED
Solid green Connected and communicating with the Avigilon Access
Control Core board.
Solid red Connection error. Try the following:
Power cycle the Elevator Board.
l
Unplug and replug the USB cable.
l
Restart the device in the Avigilon Alta Control Center.
l
Overview
1 Power input 7 Relay LEDs 1 - 16
2 Reader Power LEDs
8 Inputs 1 - 16
3 USB port
9 RESET button
4 Board Status LED 10 Board ID LED
5 Board Power LED
11 OVERRIDE SWITCH terminals (future use)
6 ADMIN button
1 - Installing
1. Screw the included standoffs into the holes labeled '1' on the back of the Elevator
Board mounting plate.
2. Fasten the board to an enclosure by inserting the included mounting screws and
washers into the back of the enclosure, and then screwing them into the
standoffs.
3. Connect the Elevator Board to the Access Control Core using the included USB
cable.