Avigilon OP-CR-SDC Quick Start Manual

Single Door Controller
Quick Start Guide
OP-CR-SDC
What's Included
Single Door Controller Cover Mounting backplate
Drywall anchors Electrical box screws Set screw for securing
SDC to backplate
Self-tapping screws Hex key for set screw
Overview
1 Admin button, Status LED indicator
2
Ethernet port
3 USB ports
4
Port LED indicators
Status LED Indicator
Status LED Description
Solid white Normal operation
Solid cyan Booting
Solid yellow Restoring software
Blinking yellow Updating software
Solid blue Unprovisioned state
Solid purple Connected to Avigilon Alta Access app
Blinking purple Ready to connect to Avigilon Alta Access app
Blinking red No internet
Solid red Error, see Avigilon Alta Control Center
Port LED Indicators
Port LED Description
Avigilon readers or Wiegand Readers Solid Normal operation
Blinking Error state
Sensors, including REX and Contact Sensors Solid Active
Blinking EOL shorted or cut
Lock hardware including relays Solid Relay is energized
Blinking Fault detection
1 - Mounting
1. Attach the backplate to a single or double gang box using the included electrical
box screws (two or four screws, respectively).
Tip: Use the included drywall anchors and self-
tapping screws on drywall for added stability.
2. Snap the Single Door Controller onto the backplate. Ensure the side clips on the
backplate (a) fit into their notches on the back of the controller (b).
3. Use the included hex key to tighten the pre-installed set screw on the Single Door
Controller to secure it to the backplate.