Bosch WQB245ALSN User Manual And Installation Instructions page 45

Fault
The drying time is too
long.
The crease-removal
function takes too
long.
Humming, whirring or
pumping noises.
The laundry is too
damp.
Cause and troubleshooting
Regularly dry a load weighing more than 3 kg of
▶
damp laundry until the programme ends.
The appliance's ventilation opening is blocked.
Ensure that the ventilation opening of the appliance
▶
is kept clear.
Heat exchanger is soiled.
Run the basic appliance care programme
▶
→ Page 39.
A low ambient temperature extends the duration of the
crease-removal function.
No action required.
Not a fault. The compressor, compressor ventilation or
condensation pump is active.
No action required.
The selected programme is unsuitable for the type of
fabric.
Set a time programme for subsequent drying.
▶
→ Page 26
The load is too large.
Observe the programme's maximum load capacity.
▶
→ Page 25
After the end of the programme, warm laundry feels
damper than it actually is.
Remove the laundry from the drum as soon as the
1.
drying programme has finished.
Spread the items of laundry for cooling.
2.
The selected dryness level is unsuitable.
Change the dryness level. → Page 34
▶
The dryness level is not adjusted.
Adjust the dryness level. → Page 34
▶
The load is too small.
Set a time programme for subsequent drying.
▶
→ Page 26
The moisture sensor is dirty.
Clean the moisture sensor. → Page 41
▶
The appliance has interrupted the drying process due
to the condensation container being full.
Empty the condensation container. → Page 33
▶
Troubleshooting en
45