Installing The Software Update; Resetting The Appliance Network Settings; Remote Start; Intelligent Programme Recommendation - Bosch WQB245ALSN User Manual And Installation Instructions

Note: To exit the Home Connect set-
tings, press and hold ⁠ Remote
Start for approx. 3 seconds.
15.5 Installing the software
update
Note: If a software update is avail-
able, a message appears in the
Home Connect app.
To install the software update, fol-
▶
low the instructions in the
Home Connect app.
a The control panel is partially
locked during the installation.
a In the event of a malfunction, in-
stallation may take up to
40 minutes. Do not reset the net-
work settings or the appliance to
the factory settings.
15.6 Resetting the appliance
network settings
Press and hold ⁠ Remote Start
1.
for approx. 3 seconds.
Press ⁠ Remote Start repeatedly
2.
until the display shows "rES".
Press and hold
3.
3 seconds.
a The network settings are reset.
15.7 Remote start
Enable the appliance for remote start
via the Home Connect app.
Note
Remote start will be deactivated in
the following circumstances:
¡ The appliance door is opened.
⁠ is pressed.
¡
⁠ Remote Start is pressed.
¡
¡ Following a power cut.
⁠ for approx.
Activating remote start
Requirements
¡ The appliance door is closed.
¡ The refresher tank is not empty.
Press ⁠ Remote Start .
▶
a ⁠ Remote Start lights up and the
appliance is enabled for remote
start via the Home Connect app.
Deactivating remote start
Press ⁠ Remote Start .
▶
a ⁠ Remote Start goes out.
15.8 Intelligent programme
recommendation
When you activate the intelligent pro-
gramme recommendation, your appli-
ance recommends a suitable pro-
gramme for drying the laundry once
you have washed your laundry in the
washing machine.
Intelligent programme
recommendation
Requirements
¡ Your washing machine has the
Home Connect function.
¡ Your washing machine and your
dryer must be connected to your
home network and registered in
your Home Connect app.
Press ⁠ SmartDry .
1.
a The appliance detects a suitable
programme. To cancel the pro-
cess, set a different programme or
switch the appliance to standby
mode.
a If the appliance finds a suitable
programme, the display for the
programme lights up and the pro-
gramme information is displayed.
a If the appliance does not find a
suitable programme, a signal tone
sounds and the display shows "-
--" .
Home Connect en
37