Replacing The Cover - Asus T2-PH2 Quick Install Manual

Replacing the cover

Replacing the cover Replacing the cover Replacing the cover Replacing the cover
B B B B B
A A A A A
A A A A A
1. Fit the cover tabs with the
chassis rail and the front panel
tabs (A), then lower the rear
edge of the cover as shown
(B).
The PSU has a 115 V/230 V voltage selector
switch located beside the power connector. Use
this switch to select the appropriate system
input voltage according to the voltage supply in
your area.
N O T E . N O T E . N O T E . The voltage selector is set to
N O T E . N O T E .
230 V by default.
If the voltage supply in your area is 100-127 V,
set the switch to 115 V. If the voltage supply in
your area is 200-240 V, set the switch to 230 V.
W A R N I N G ! W A R N I N G ! W A R N I N G ! W A R N I N G ! W A R N I N G ! Setting the switch to 115 V in a 230 V environment will
seriously damage the system!
v i i i v i i i
v i i i v i i i v i i i
B B B B B
2. Secure the cover with three
screws.