Safety And International Symbols - Snapper SST-CV Quick Start Manual

e WARNING: Never use blades or
i Use of any other accessories or
SAFETY
RULES Crasas
soso
1-2
attachments
will increase the risk
of injury.
OPERATION INSTRUCTIONS ........ccccaeaeecees 3
OPERATION INSTRUCTIONS - EDGER UNIT ......... 4 e THROWN OBJECTS: People
MAINTENANCE
...0cococcccccococrcc cr
5
around the operation of this unit
SERVICE/ADJUSTMENTS ...000oooooooo
oo...
6
must be warned that debris and
TROUBLESHOOTING GUIDE ........oooooocooo ooo. 7
objects: An Thrown ton Un,
STORAGE
ccir epiros e
a ben 7
+ KEEP FEET AWAY FROM BLADE:
WARRANTY INFORMATION
.............0ceeuueees 8
When using the edger attachment
NOTES oia td Bale 9 always keep cutting unit in front of
you. Always move forward away
from your body.
SAFETY AND INTERNATIONAL SYMBOLS
This operator's manual describes safety and international
symbols and pictographs that appear on this product. Read the
operator's manuai for complete safety, assembly, operating,
Do not allow a person to use this unit unless instructions are
maintenance and repair information.
read and understood. Never allow children to operate or play
with the unit.
SYMBOL MEANING
Do not operate this unit when tired, ill or under the influence of
+ SAFETY ALERT SYMBOL alcohol, drugs, or medication.
Indicates danger, warning or
caution. May be used in conjunction
with other symbols or pictographs.
Always wear heavy, long pants, boots, gloves, and a long
sleeve shirt. Do not wear loose clothing, jewelry, short pants,
sandals, or go barefoot. Secure hair so it is above
"WARNING - READ OPERATOR'S shoulder level.
MANUAL ' j
Read the operator's manual(s) and
Inspect unit before each use. Replace damaged parts. Check
: : ni or damaged in any way. Make sure the cutting attachment is
result in serious injury to the
A
i
operator and/or bystanders properly installed and securely fastened. Be sure the cutting
i attachment shield is properly attached, and in the position
+ WEAR EYE AND HEARING recommended by the manufacturer. Use only flexible, non-
PROTECTION metallic line recommended by the manufacturer. Never use,
WARNING: Thrown objects and for example, wire or wire-rope which can break off and
loud noise can cause severe eye become a dangerous projectile.
injury and hearing loss. Wear eye
protection meeting ANSI Z87.1
standards and ear protection when
operating this unit. Use a full face
shield when needed.
Keep firm footing and balance. Do not over-reach. Keep cutting
attachment below waist level. Keep all parts of your body away
from the rotating cutting attachment and hot surfaces.
Never start or run the unit inside a closed room or building;
e KEEP BYSTANDERS AWAY breathing exhaust fumes can kill.
WARNING: Keep ail bystanders,
especially children and pets,
e
Pour fuel outdoors where there are no sparks and flames.
Slowly remove the fuel cap only after stopping the engine. Do
es em) trem the not smoke while fueling. Wipe spilled fuel from the unit. Move
` at least 10 ft. (3 m) away from the fueling source and site
e THROWN OBJECTS AND before starting engine.
ROTATING CUTTER CAN
CAUSE SEVERE INJURY
WARNING: Do not operate without
the cutting attachment shield in
place. Keep away from the rotating
cutting attachment.