Nu-Flame EVOLUTION BLAZE 600 Use & Maintenance Instructions

Unit 4, Kimpton Trade & Business Centre
Minden Road, Sutton, Surrey, SM3 9PF
Tel: 020 8254 6802
USE & MAINTENANCE INSTRUCTIONS
FOR NU-FLAME BLAZE 600 NATURAL GAS FIRE
a. This fire must be installed by a properly qualified (in accordance with National & Local Regulations) Installation Engineer.
b. The connection of this appliance, and ventilation requirements are to be according to National & Local Codes.
c. The chimney should be swept before the appliance is installed.
d. Open fires are a hazard; it is recommended that a guard be fitted to provide protection for children, the elderly or infirm. (See
National & Local Regulations if any.)
e. This appliance is intended for decorative purposes only.
f. Do not throw rubbish on, or attempt to burn any materials on this appliance. Any debris or foreign matter must be removed
from the fire.
g. The appliance should be serviced by a qualified gas fitter every 12 months.
a. This appliance is fitted with an oxygen depletion sensing system, which automatically shuts off the gas supply to the main
burner if the oxygen level in the room is depleted, due to a lack of primary air, or obstructed flue that would lead to incomplete
combustion of the gas.
b. In the event that the fire shuts down due to any reason, attempt to restart it. If there is a continuing problem call in a properly
qualified specialist engineer.
c. There are no user replaceable parts in this appliance, except for the logs, Embaglow and black vermiculite available from Nu-
Flame.
d. Regularly inspect the purpose provided ventilator to check that it is free from any obstruction.
e. The chimney should be regularly checked to ensure that all the products of combustion are entering the flue & that there is no
build up of soot. If there is, the appliance must be cleaned.
a. Carefully remove the logs and dust gently with a soft brush so as not to remove the colour finish.
b. Remove the black vermiculite and Embaglow and retain for future use.
c. Carefully dust off the top of the burner with a soft brush. Again taking care not to remove the colour finish.
d. Very carefully remove any debris from the burner slots using a vacuum cleaner taking the utmost care not to damage
the finish on top of the burner.
e. Re-lay as shown in these instructions.
f. The Embaglow is a consumable item and replacements can be obtained from Nu-Flame.
®
Simulated logs manufactured from refractory fibre,
Do not use real logs as this is dangerous.
If the simulated logs need renewing please obtain
GENERAL
IMPORTANT NOTES
CLEANING THE FIRE
Page 1 of 13
IMPORTANT NOTE
are supplied with this appliance.
suitable replacements from a
Nu-Flame stockist.