Dormakaba 9212 Installation

INSTALLATION
9212i
STAND ALONE KEYPAD
SPECIFICATIONS
Features:
• 4 Independent Outputs
• 4 Independent Timers
• All Outputs Assignable by Code
• On board 5 Amp Form C Relay
• 120 Users
• Remote Triggering Input
• Keypad Programmable
Memory
Non-volatile EEPROM memory means your codes and
programming will be there whether you remove power for 5
minutes or 5 years.
Programming
All programming is accomplished entirely from the front of the
keypad. LED or Sounder guidance makes programming easy,
and changing codes a matter of seconds for an authorized
user.
Codes
These keypads allow up to 120 individual user codes to be
valid. Codes may be from 1-6 digits in length and digits may
be repeated. The Master Code is always assigned to user
location one (1).
Main Relay
This is a 5 Amp (10 Amp surge) Form-C relay which can be
toggled or timed from 1 to 90 seconds-by code.
Auxiliary Outputs
Auxiliary outputs can be individually timed from 1 to 90
seconds or act as a toggle switch, and may be triggered
individually or in combination-by code. The three auxiliary
outputs provide a 50mA sink to ground when activated.
Remote Triggering Input
This normally open loop that by default operates the Main
Relay upon activation and can be programmed to trigger
any combination of outputs. Upon a momentary closure, the
selected outputs will energize for their programmed time. The
main relay (if selected) will energize for the same time period
as the Master Code. This feature is especially useful when
controlling an electric locking device.
NOTE: As with any electronic product, the 9212i may be subject to irregularities in the AC power line. This can cause malfunction
or unstable operation. Connecting the 9212i to a suitable DC power supply will limit the effects of AC fluctuation on the keypad.
IS9212i
Keypress Feedback / Audible Keypress
These keypads will acknowledge a keypress by momentarily
illuminating the yellow LED. This can be turned off through
programming.
Keypad Active Output
These keypads can be programmed to energize a voltage
output whenever a key is touched. This can be used to turn on
accessories such as lights, CCTV camera, or notify a guard.
Auto-Entry
This feature is used when the need for the code not to be
followed by the * key is desired. The user only needs to
enter their code number and the relay will activate for the
programmed relay time. To use this feature, the user codes
must be the same length as the master code.
Technical Notes:
To avoid ESD (Electro-Static Discharge) from interfering
with the operation of the 9212i keypad, ground the negative
terminal of the keypad to earth ground. If the power supply
can not be grounded, then the case should be grounded. For
24VDC operation, remove jumper J2 (see Fig. 5).
Packing Checklist:
9212i Keypad
Ten (10) Conductor Wiring Harness (1)
Slotted Screws (2)
Security Screws (2)
Installation
Diode (1)
Voltage
12-24 VAC/VDC
Current Rating
@ 12VDC 8mA typ - 35mA w/relay energized
@ 24VDC 16mA typ - 45mA w/relay energized
Temperature
-20°F to 130°F (-28°C to 54°C)
Output
Main relay: 5A, form-C @24VDC, 10A surge
Outputs 2-4 are 50mA neg voltage outputs
© 2024 dormakaba Canada Inc
www.dormakaba.us • Phone: 1.800.265.6630 • E-mail: sales_RCI@dormakaba.com
ECN2313
R05-24AD