JUNO JRN 20882 Operating Instructions Manual page 32

32 electrolux
5. Separate parts Ha, Hb, Hc, Hd as
shown in the figure.
6. Place guide (Ha) on the inside part of
the furniture door, up and down as
shown in the figure and mark the
position of external holes. After
having drilled holes, fix the guide with
the screws supplied.
7. Fix cover (Hc) on guide (Ha) until it
clips into place.
GB
8. Open the appliance door and the
furniture door at 90°. Insert the small
square (Hb) into guide (Ha). Put
together the appliance door and the
furniture door and mark the holes as
indicated in the figure.
9. Remove the squares and mark a
distance of 8 mm from the outer
edge of the door where the nail must
be fitted (K).
10. Place the small square on the guide
again and fix it with the screws
supplied.
Should the alignment of the furniture
door be
clearance of slots.
At the end of this procedure, it is
necessary to check if the door of the
furniture closes properly.
necessary, use the