If this appliance featuring magnetic door seals is to replace an older appliance having a spring lock (latch) on the door or lid, be sure to make that spring lock unusable before you discard the old appliance. This will prevent it from becoming a death-trap for a child.
Under no circumstances ventilation as a failure to do this will result in should solid ice be forced off the liner. Solid ice component failure and possible food loss. See should be allowed to thaw when defrosting the installation instructions.
In this case the dial must be set to a higher Small pieces may even be cooked still frozen, directly temperature to allow automatic defrosting and from the freezer: in this case, cooking will take longer.
- unscrew the light cover securing screw. - unhook the moving part as shown in the figure. If the light does not come on when the door is open, check that it is screwed into place properly. If it still does not light up, change the bulb.
D037 compartment proceed as follows: 1. pull out the plug from the wall socket or turn the thermostat knob to the ÇOÈ setting; 2. remove any stored food, wrap it in several layers of newspaper and put it in a cool place;...
For safety reasons, minimum ventilation must be as min. shown in Fig. Attention: keep ventilation openings clear of obstruction. D567 It is necessary that the niche is provided with a conduct of ventilation having the following dimensions: Depth 50 mm Width...
Page 9
Apply covers (B) on joint cover lugs and into hinge holes. D726 Position the runners (A) at the top and bottom of the inside of the kitchen unit as shown in Fig. and mark the position of the external holes.
Page 10
1) Using a screwdriver release bracket (1) by pressing on the internal spring (Fig. 11) and withdraw it from its seat together with the door; 2) remove plug (2) and fit it in the hole left open on the opposite side; 180°...