Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for JUNO JKG8494
Summary of Contents for JUNO JKG8494
- Page 1 JKG 8495 GEBRAUCHSANWEISUNG OPERATING INSTRUCTIONS 2222 148-16...
-
Page 2: General Safety
If this appliance featuring magnetic door seals is to replace an older appliance having a spring lock (latch) on the door or lid, be sure to make that spring lock unusable before you discard the old appliance. This will prevent it from becoming a death-trap for a child. -
Page 3: Environment Protection
Installation - Door reversibility - Building-in instructions ........ -
Page 4: Operation
In this case the dial must be set to a higher temperature to allow automatic defrosting and therefore reduced energy consumption. - Page 5 24 hrs. is shown on the rating plate; For safety, store in this way only one or two days ¥ the freezing process takes 24 hours. No further at the most.
-
Page 6: Maintenance
- unscrew the light cover securing screw. - unhook the moving part as shown in the figure. If the light does not come on when the door is open, check that it is screwed into place properly. If it still does not light up, change the bulb. -
Page 7: Customer Service And Spare Parts
(see ÒDefrostingÓ that: section). ¥ the plug is firmly in the wall socket and the mains ¥ If your appliance is still not working properly after power switch is on; making the above checks, contact the nearest service centre. -
Page 8: Door Reversibility
Remove the pins (P) and (P1) Remove (P) from both sides and the door. Remove (A) from the left and (B-C) from the right side and refit them on the opposite side. Refit the door and (P) on the left side. - Page 9 D023 Open the door and push the appliance against the side of the kitchen unit opposite to that of appliance hinges. Fasten the appliance with 4 screws provided in the kit included with the appliance. Snap vent grille (C) and hinge cover (D) into position.
- Page 10 Separate parts A, B, C, D as shown in the figure PR266 Place guide (A) on the inside part of the furniture door, up and down as shown in the figure and mark the position of external holes. After having drilled holes, fix the guide with the screws supplied.
- Page 11 Should the lining up of the furniture door be necessary, use the clearance of slots. At the end of operations, it is necessary to check if the door of the furniture closes properly. PR168 Fix cover (D) on guide (B) until it clips into place.