Keyboard, Mouse And Video Configuration; Dkvm-Ip1 Switch Keyboard Settings - D-Link DKVM-IP1 Manual

When configuring with a serial terminal, reset the DKVM-IP1 switch and immediately press the
" ESC " key. You will see some device information, and a " => " prompt. Enter "config", press
" Enter " key and wait for a few seconds for the configuration questions to appear.
As you proceed, the following questions will appear on the screen. To accept the default values
which are shown in square brackets below, press "Enter" key.
IP auto configuration (non/dhcp/bootp) [dhcp]:
IP [192.168.0.70]:
Net mask [255.255.255.0]:
Gateway (0.0.0.0 for none) [0.0.0.0]:
IP auto configuration
With this option, you can specify whether the DKVM-IP1 switch should get its network settings
from a DHCP or BOOTP server. For DHCP, enter "dhcp", and for BOOTP enter "bootp". If you
do not specify any of these, the IP auto configuration is disabled and subsequently you will be
asked for the following network settings.
IP address
The IP address the DKVM-IP1 switch uses. This option is only available if IP auto configuration
is disabled.
Net mask
The net mask of the connected IP subnet. This option is only available if IP auto configuration
is disabled.
Gateway address
The IP address of the default router for the connected IP subnet. If you do not have a default
router, enter 0.0.0.0. This option is only available if IP auto configuration is disabled.

4.1.3 Keyboard, Mouse and Video configuration

Between the DKVM-IP1 switch and the host, there are two interfaces available for transmitting
keyboard and mouse data: USB and PS/2. The correct operation of the remote mouse depends
on several settings which will be discussed in the following subsections.

4.1.3.1 DKVM-IP1 switch keyboard settings

The DKVM-IP1 switch settings for the host's keyboard type have to be corrected in order to
make the remote keyboard work properly. Check the settings in the DKVM-IP1 switch
front-end. See section 6.4.3 in details.
Parameter
Bits/second
Data bits
Parity
Stop bits
Flow Control
Table 4-2. Serial line parameters
Value
115200
8
No
1
None
14