D-Link DES-3225G Series User Manual page 96

Select the desired setting in the Ports field: 1 to 4, 5 to 8, 9 to 12, 13 to 16, 17 to 20, 21-S1P2, or Slot 2 and the
desired increment setting in the Polling Interval field: 2 sec, 5 sec, 15 sec, 30 sec, 1 min, or Suspend. Pressing
CLEAR COUNTER resets the counters on this screen.
The statistic counters displayed are defined as follows:
Speed If the link is up, the speed and duplex status will be displayed; if the link is down "-" will be displayed.
% Utilization This shows the percentage of available bandwidth each port is using over the amount of time
specified by the update interval. For example, when a 10 Mbps port is relaying packets at 5 Mbps, the utilization is
50%.
Bytes Recv. The number of good bytes received. This also includes local and dropped packets.
Bytes Sent The number of good bytes sent from the respective port.
Frames Recv. The number of good frames received. This also includes local and dropped packets.
Frames Sent The number of good frames sent from the respective port.
Total Bytes Recv. The number of bytes received, good and bad.
Total Frames Recv. The number of frames received, good and bad.
Last Seen MAC The MAC address of the last device that sent packets over this port.
86
Figure 6-57. Port Traffic Statistics screen
24-port NWay Ethernet Switch User's Guide
Using the Console Interface