Table of Contents
Advertisement
The washer has two water inlet filters to
protect each inlet valve. These filters
should be checked every 6 months and
cleaned, if necessary. (This may need
to be performed more frequently with
some water supplies).
^ Turn off the water valve.
^ Unscrew the inlet hose from the valve
by turning the connector
counterclockwise using a wrench, if
necessary.
^ Remove the rubber seal, , from the
connector.
^ Using needle nose pliers, grasp the
plastic filter, , and pull it out of the
hose connector.
^ Clean the filter under running water
and carefully remove any large
particles. Replace the filter and seal
and reconnect the hose.
^ Slowly turn on the valve and check
for leaks.
,
Inspect the hose regularly. The
hose must be in good condition to
withstand high water pressure. The
hose should be replaced if there are
cracks in the surface, or if it has
been otherwise damaged or cut.
^ Using a wrench, carefully loosen and
remove the plastic hose connector on
the inlet valve.
^ Using needle nose pliers, remove the
plastic filter by pulling on the bar (see
illustration). Rinse under water and
return parts.
Both filters
place after cleaning.
be put back in
25
Hide quick links:
Advertisement
Table of Contents
