Summary of Contents for Fisher-Price Power Wheels Harley-Davidson Police Motorcycle
Page 1
This Owner's Manual is provided and hosted by Appliance Factory Parts. FISHER PRICE 74287 Owner's Manual Shop genuine replacement parts for FISHER PRICE 74287 Find Your FISHER PRICE Ride On Parts - Select From 999 Models -------- Manual continues below --------...
Page 2
Sound and Light Box requires three “AA” (LR6) alkaline batteries (not included). Harley-Davidson is a registered trademark and the motorcycle sound is a trademark of H-D Michigan, Inc. used under license. Fisher-Price, Power Wheels by Fisher-Price and Power Lock are U.S. trademarks of Mattel, Inc. Owner's Manual with Assembly Instructions...
• Use this vehicle ONLY outdoors. Most interior flooring can 1-800-348-0751 from 8 AM to 6 PM (EST) Monday be damaged by riding this vehicle indoors. Fisher-Price ® through Friday. Trained customer service representatives will not be responsible for damage to floors if this vehicle are available to take your call in English or French.
Warnings and Cautions ELECTRICAL HAZARD WARNING • Battery can fall out and injure a child if vehicle tips over. Always use battery clamp. • PREVENT FIRE - Never modify the electrical system. Alterations could cause a fire resulting in serious injury and could also ruin the electrical system.
Parts • If you experience a problem with this product, or are missing a part, please call us at 1-800-348-0751, rather than return this product to the store. • Please identify all parts before assembly and save all packaging material until assembly is complete to ensure that no parts are discarded.
Page 6
Parts Exhaust Pipe Set Left - Inner Right - Inner Right - Outer Left - Outer Front Headlight Rear Headlight Seat Gas Tank Saddlebag - 2 Fork Cover Front Fork Light and Sound Box Flashing Light Lens...
Page 7
Parts Outer Inner Handgrips - 2 Shock Set - 2 Left Right Handlebar Handlebar Mirror Clamp Windshield Right Mirror Left Mirror Mirror Lens - 2 Taillight Cover Taillight Fender Tip Handlebar Harness...
Page 8
Parts Hex Bushing - 4 Axle Bushing - 2 12 Volt Charger 12 Volt Battery Round Bushing - 2 Not Shown: Label Sheet #8 x " Plastite Screw – 68* .437 (Large Diameter) Cap Nut - 4* .354 (Small Diameter) Cap Nut - 2* #8 x "...
Parts Diagram Note: Some parts shown are assembled on both sides of the vehicle. Fender Tip Vehicle Frame Left Handlebar Vehicle Body Light and Sound Box Left Mirror Seat Front Fork Mirror Clamp Wheel - 2 Handgrip - 2 Taillight Gas Tank Round Bushing - 2 Taillight Cover...
Battery Charging About Thermal Fuses ELECTRICAL HAZARD Your Power Wheels 12 volt battery is equipped with a built-in thermal fuse. The thermal fuse is a self-resetting WARNING safety device which automatically “trips” and shuts down operation of the vehicle if the vehicle is overloaded or the driving conditions too severe.
Page 11
Battery Charging Battery Clamp Battery Charger Connector • Plug the charger connector into the battery • Plug the charger into a standard 120 volt wall outlet Note: If power flow to the wall outlet is controlled by a Battery switch, make sure the switch is “ON”. •...
Assembly WARNING Children can be harmed by small parts, sharp edges and sharp points in the vehicle’s unassembled state, or by electrical items. Care should be taken in unpacking and assembly of the vehicle. Children should not handle parts, including the battery, or help in assembly of the vehicle. Vehicle Body #8 x...
Page 13
Assembly Large Rectangular Opening Vehicle Body Square Opening Motor High Speed Harness Hook-Up Motor Harness Narrow Rectangular Connector Opening Top View • Fit the motor harness between the vehicle body tabs. Vehicle Frame • Position the vehicle body on top of the vehicle frame. •...
Page 14
Assembly Right Exhaust Pipe - Inner Half Right Footboard Vehicle Vehicle Frame Frame Hint: Use a long-shafted screwdriver to complete this • The right footboard was inserted in the vehicle frame at assembly step. the factory. Make sure the right footboard is in place. •...
Page 15
Assembly Right Exhaust Pipe Wheel Axle .437" .437 (Large Diameter) Cap Nut .437 Cap Nut • Separate the fork axle from the two wheel axles. (The fork axle is shorter than the wheels axles.) Set the fork axle aside for assembly step 41. •...
Page 16
Assembly Saddlebag Vehicle Frame Notch Axle Bushing Groove Rear Fork Arm Rear Fork Arm Wheel Back View (with Hex Bushings) • Lift the pretend buckles on a saddlebag to open Back View the saddlebag. • Fit the tab on the back surface of the saddlebag into the •...
Page 17
Assembly Front Headlight Flashing Light Lens Notch Assembly Light Base Wire Notch Notch Wire Retainers • Place the flashing light lens on the light base. Align the notch in the flashing light lens with the notch in the light base. •...
Page 18
Assembly Front Fork Cover “Lens” • Turn the headlight assembly over so that the front faces you. Insert two #8 x " screws into the headlight assembly. Front Fork • Tighten both screws using a Phillips screwdriver. Rectangular Do not over-tighten. Openings •...
Page 19
Assembly Wire Cover Base End Handlebar Right Mirror Peg Harness Grip Area Additional Hole Switch Cover Right Handlebar Right Handlebar • Fit the right mirror peg through the hole in the right handlebar and into the hole in the switch cover. •...
Page 20
Assembly Left Mirror Mirror Clamp Right Handlebar Left Handlebar Handlebar Harness Left Handlebar • Fit the left mirror to the left handlebar, as shown. • Fit and hold the mirror clamp to the other side of the left handlebar. • Insert two #8 x "...
Page 21
Assembly Windshield Handlebar Harness Handlebar Harness Inset Retainer Handlebar • Loop the handlebar harness Assembly around the retainer in the neck of the vehicle frame. Retainer • Position the handlebar assembly face down. • Position the windshield curved side down. •...
Page 22
Assembly .354 (Small Diameter) Cap Nut Neck of Vehicle Body Front Fork Handlebar Steering Assembly Stop • Fit the tab on the steering stop into the curved slot in the lower steering bushing • Hold the steering stop in place. •...
Page 23
Assembly Battery Compartment Door Handlebar Harness Battery Compartment Wire Clip Sound Box 1.5V x 3 “AA” (LR6) Handlebar SHOWN ACTUAL SIZE Harness Inset • Loosen the screw in the sound box battery compartment door using a Phillips screwdriver and open the battery compartment.
Page 24
Assembly Buttons Light and PUSH Sound Box Gas Tank HERE Seat Tab Tabs Seat Tab Vehicle Body Gas Tank Slot Vehicle Frame • Balance the light and sound box on the vehicle body. (The speaker should face down.) • Fit the tabs at the bottom of the gas tank under the front end of the vehicle body.
Page 25
Assembly Round Front Wheel Bushing Fender Axle Arrow .437 (Large Diameter) Cap Nut Shock Handlebar Handlebar Front Fork Front Fork Tabs Tabs • Position the vehicle upside down. • Note the arrow on the underside of the front fender. • Position the front fender so that the arrow points towards Barrel Side the front of the vehicle.
Page 26
Assembly Hint: You may need to push the shock outward slightly to Wheel (with Hex Bushings) fit the round bushing. • Continue to slide the wheel axle through the round bushing and then the shock. Shock Shock • Fit a .437 (large diameter) cap nut on the end of the Wheel Axle wheel axle.
Label Decoration Proper label application will help to keep the labels looking their best! When applying labels, keep the following guidelines in mind: • Wash your hands before applying the labels. • Before applying the labels, wipe the surface of the vehicle with a clean, dry cloth to remove any dust or oils. •...
Battery Installation IMPORTANT! Use only Power Wheels ® 12 volt battery. Battery Clamp Use of any other battery will damage your vehicle. Make sure that you charge the battery for at least 18 hours using the enclosed Power Wheels ® 12 volt charger before operating your vehicle for the first time.
Battery Care Battery Care and Disposal and Disposal Care Disposal If a battery leak develops, avoid contact with the leaking • Your Power Wheels ® battery is sealed lead-acid battery. acid and place the damaged battery in a plastic bag. See They must be recycled or disposed of in an environ- information below for proper disposal.
Rules for Safe Driving RIDING HAZARD 7. Do not allow your child to drive on sloped or inclined WARNING surfaces. Restrict your child’s driving to generally level ground ONLY! 8. Do not allow your child to drive down or across a Prevent Injuries and Deaths steep slope.
How to Operate Your Vehicle IMPORTANT! As assembled, your vehicle is ready to roll in low speed (2 mph, maximum). When your child is ready to drive the vehicle in high speed (5 mph, maximum), follow the instructions on this page to connect the high speed hook-up and use the power boost button. To Stop Beginner Use - Low Speed Drive...
How to Operate Your Vehicle Bumper-to-Bumper* Limited Warranty Advanced Use - High Speed IMPORTANT! Your child should not drive the vehicle in *One year limited warranty from the date of HIGH SPEED from a stopped position. Always start in purchase on the Power Wheels ®...
Problems and Solutions Guide IMPORTANT! If you experience a problem with your vehicle, first check the Problems and Solutions Guide below. If you still experience a problem, please contact Power Wheels ® Consumer Relations, toll-free at 1-800-348-0751 between 8 AM and 6 PM (EST) Monday through Friday. Or, contact your local Power Wheels authorized service center.
Page 35
Problems and Solutions Guide Problem Possible Cause Solution Vehicle was running but Loose wire or loose connectors Check all wires and connectors. Make sure the motor suddenly stopped harness connector is tightly plugged into the battery, and that there are no loose wires around the motors. Tripped thermal fuse Each Power Wheels ®...
Page 36
Problems and Solutions Guide Problem Possible Cause Solution Problem Possible Cause Solution Vehicle runs sluggishly (cont.) Battery needs charging Be sure to charge the battery after each use. Battery is old and will not accept Even with proper care, a rechargeable battery does not accept full charge last forever.
Authorized Service Centers We are continually expanding our Authorized Service Center Network. Please check this listing for the Authorized Service Center nearest you. If there is not one in your area, please call Power Wheels ® Consumer Relations at 1-800-348-0751. ALABAMA SAN JOSE - California Electric Service Center, PORT ST.
Page 38
Authorized Service Centers FAIRVIEW HEIGHTS - Rapid Rentals, 720 Lincoln LOUISVILLE - Maury’s Fluorescent & Appliance DETROIT (ROYAL OAK) - McNichols Electric Service, Highway, 62087, (618) 632-0630 Service, 1521 Bardstown Road, 40205, 4115 West 13 Mile Road, 48072, (810) 288-5135 (502) 456-1671 GRANITE - Midwest Golf Car &...
Page 39
Authorized Service Centers NEVADA NORTH CAROLINA OREGON LAS VEGAS - Burney’s Commercial Service, Inc., ANDREWS - Smoky Mountain Hobbies, 200 Stewart EUGENE - Oldfield’s, 1465 West 7th, 97402, 4480 Aldebaran Avennue, 89103, (702) 736-0006 Road, 28901, (828) 321-9836 (541) 485-6000, (800) 944-0238 MINDEN - Valley Home &...
Page 40
Authorized Service Centers FORT MILL - Service Engines Inc., 3356 SC Highway MIDLAND - Midland Tool Specialty, 918 South Main, WEST VIRGINIA 51, 29715, (803) 548-1778, (800) 845-1191 79701, (915) 682-4647, (800) 499-0755 BECKLEY - Jerry’s Detectors, Vacuum & Appl. Svc., GREENWOOD - Bikes &...
Need help?
Do you have a question about the Power Wheels Harley-Davidson Police Motorcycle and is the answer not in the manual?
Questions and answers