Haier TDC1314S User Manual page 14

Channel set up:
By pressing MENU button ,and then pressing VOL-/+ button it will bring you to
Channel Set Up. You will see the following display on TV screen.
Follow the procedure below to select above options:
1.Press CH (+) button to go up and pressCH (-) button to go down the menu.
2.Press VOL (+) button or VOL (-) button to select your preference.
Channel system: Press the V-/+ buttons to select the correct channel system.
In general, you can set it as "AUTO" AUTO,NTSC and NTSC443 will
display in turn .
Current Ch. : Press VOL(+) button to go up and VOL (-) button to go down to set the
channel position. The display will show the current playing channel.
Skip :Press VOL(+) button or VOL(-) button to add or delete the channel from the
stored memory.
Antenna: Press VOL (+) button or VOL(-) button to select Air or Cable.
Channel Coverage by Antenna:
Antenna Type
VHF
UHF
CATV
Fine tune: If the picture and/or sound are poor, try using the FINE TUNE feature.
Do not use this feature unless reception is poor.
button to do Fine tune.
Auto program: Press VOL (+) button or VOL (-) button to do auto program. In this
process, the search automatically adds only the active channels in your area to the
TV's memory. It deletes any channels on which there is no broadcast
Note: After auto-search finished, the Air mode is preset. If you use cable, you must
change to cable mode in the set up menu.
Channel
Channel system
Antenna
Skip
Current Ch.
Fine
Auto Program
Channel Range
2-13
14-69
1-125
Auto
TV
off
0
Press VOL (+) button or VOL (-)