Table of Contents
Advertisement
In the Multiple PVC configuration menu configure the WAN interface settings described in the table below.
A
LL CONNECTIONS MUST CONFIGURE
Select index to set
Item Name
VPI
VCI
Encapsulation
PPP Connections must configure:
Login User Name
Login Password
Confirm Password
Authentication
Connect on Demand
Idle Time
IPoA Connections must configure:
IP Unnumbered
IP Address
Subnet Mask
Connect / Disconnect
If you have enabled the Connect on Demand feature, the Router will begin to negotiate the WAN connection
upon restarting. If the Connect on Demand feature has been disabled, click the Connect button to initiate the
connection via the ADSL WAN interface. The process will take a few seconds. To end the WAN connection,
click on the Disconnect button.
DSL-604+ ADSL Ethernet Router User's Guide
:
Choose the index number you wish to modify or delete.
Type in a new name for this profile.
Type in the new VPI setting (0-255)
Type in the new VCI setting (32-65535)
From the drop-down menu select PPPoE LLC, PPPoA LLC,
PPPoA VC mux, IPoA LLC, IPoA VC mux, Bridge LLC, or Bridge VC
mux. Default for Index 1 = PPPoA LLC.
Used for authentication by your network service provider.
Used for authentication by your network service provider
Type the same password to confirm it.
Protocol used to confirm the identity of the subscriber. Choose chap
(default) or pap form the drop-down menu.
Select enabled or disabled. When this function is enabled the router will
connect any workstation on your LAN to the Internet upon request. If this
function is disabled, it will be necessary to access this menu and hit the
Connect button each time you want to establish a connection to the
WAN or the Internet.
A value of 0 means that the PPP connection will remain connected. If
your network account is billed according to the amount of time the
Router is actually connected to the Internet, enter an appropriate Idle
Time value (in seconds). This will disconnect the Router after the WAN
connection has been idle for the amount of time specified. The default
value = 0.
This is enabled by default and therefore no IP settings need to be
entered for the account. If this is disabled, (global) IP settings must be
configured for the WAN interface.
If IP Unnumbered is disabled, type in the WAN IP address for the
account.
If IP Unnumbered is disabled, type in the subnet mask for the WAN
interface.
WAN Connection Configuration
21
Advertisement
Table of Contents
