SubSurface Instruments AML PRO Series Operator's Manual page 25

CONNECTING YOUR AML PRO TO THE COMPUTER
2
After acquiring the GPS logs from your work-site, turn your
1
AML Pro OFF before connecting it to the computer. Your
computer MUST be connected to Internet to complete
this process.
Plug the provided USB cord into the unit. DO NOT TURN
2
THE AML Pro ON. Plug the other end of the cord into a
USB port in the computer. As soon as you plug into the
USB port the computer will automatically start installing the
3
drivers for the unit into your system (
Internet
Your computer will prompt a successful installation
3
message after it's done installing the drivers. - This is a
Windows process and may vary depending on your
computer's Operating System -
4
Note: USB PWR status message will show on the screen for 10 seconds.
Turn the AML unit ON and start up messages will be
4
displayed. Wait until the status message changes to
"OPERATE". You are now ready to start.
).
Important: from the
AML PRO SERIES
25