Electro-Harmonix POG3 Manual page 3

hear the filter sweep on the effect
voices.
3. Turn up the Q knob to maximum
and move the FILTER slider again.
This time the filter sweep will sound
more dramatic and resonant.
4. Set the FILTER slider to the lower
half of its range.
5. Turn up the ENV knob to about 3
o'clock. Now, when you play, the
envelope sweeps the filter fre-
quency.
6. When ENV is set to its positive half,
the envelope sweeps upward from
the FILTER slider setting. When ENV
is in its negative half, the envelope
sweeps downward from the FILTER
slider setting.
7. Press the DRY FILTER button to route
dry signal through the filter effect.
DETUNE Controls
1. The DETUNE slider is a depth control
for the Detune chorus/doubling
effect.
2. Set the DETUNE slider to 50%. The
Detune effect will be heard on the
+1 and +2 voices.
3. Press the DRY DETUNE button to
enable it. The dry signal now goes
through the DETUNE effect as well.
Saving Presets
1. Once you create a setting you like,
save it by pressing and holding the
center of the NavCoder knob for
just over one second.
2. If the current preset slot is empty,
Preset Saved is displayed and all
slider LEDs blink for about a second.
3. You can release the NavCoder once
Preset Saved is shown. The preset
is saved.
4. If you are modifying or saving on
an existing preset, the POG3 will
ask you to Cancel, Save, or Save As.
Choose Save to save the preset to
the same preset number or Save As
to save to a different location.
Recalling Presets
Footswitches
1. If in LIVE mode, press and release
either PRESET
current preset number.
2. The green PRESET LED between the
footswitches lights solid.
3. Now each press of the PRESET
footswitch will scroll up through the
preset number and immediately
load the preset.
4. Each press of the PRESET
switch will scroll down through the
preset number and immediately
load the preset.
5. Press and hold either PRESET
or to rapidly scroll through the
presets.
Navcoder
1. If in LIVE mode, rotate the NavCoder
knob to the desired preset.
2. Press and release the center of the
NavCoder. The preset loads and the
green PRESET LED lights solid.
3. Turn the NavCoder in either direction
to automatically load the next
preset.
LIVE / Preset Toggle
1. NavCoder: If a preset is activated,
press and release the center of
the NavCoder knob to unload the
preset and enter LIVE mode.
2. NavCoder: Press and release the
NavCoder while in LIVE mode to
load the currently selected preset.
3. Footswitches: Press both PRESET
footswitches simultaneously to
unload the current preset and
enter LIVE mode.
- 3 -
or to load the
foot-