Thermann Owner’s Guide Gas Continuous Flow Water Heaters IMPORTANT SAFETY INSTRUCTIONS IMPORTANT SAFETY INSTRUCTIONS IMPORTANT SAFETY INSTRUCTIONS 1. Do not hang washing or other materials adjacent to the unit. 2. Do not store flammable materials within 2 metres of the unit.
Page 5
IMPORTANT SAFETY INSTRUCTIONS MEASURES TO BE TAKEN DURING ELECTRICAL STORMS Power surges caused by lightning can cause damage to the electrical components of the unit. Turn off the main power during electrical storms. DO NOT INSTALL INDOORS Danger This unit is designed for outdoor installation. Never install indoors. It will be extremely dangerous because it will cause oxygen deficiency and incomplete combustion.
Page 6
Thermann Owner’s Guide Gas Continuous Flow Water Heaters IMPORTANT SAFETY INSTRUCTIONS IMPORTANT SAFETY INSTRUCTIONS IMPORTANT SAFETY INSTRUCTIONS DO NOT DISASSEMBLE, REPAIR OR MODIFY Warning Do not disassemble or modify the units as this may cause fire, electric shock and other accidents.
Caution Caution IMPORTANT SAFETY INSTRUCTIONS MEASURES TO BE TAKEN IN CASE OF EMERGENCY The procedure to follow in an emergency such as earthquake, flood or fire is: Close Close 1. Close all hot water taps in the house. 2. Close the gas valve and the main water valve. 3.
Gas Continuous Flow Water Heaters REMOTE CONTROL Up to three remote controls are able to be installed with your Thermann unit for complete control of your hot water. Please note, units without remote control will be set at either 50°C or 60°C (the exception is if the unit is installed as a solar booster.
Page 9
REMOTE CONTROL Operation of Controller Please read these instructions carefully before using this appliance. 1. Turn on the ON/OFF button. 2. The temperature display will read 40°C. 3. The priority indicator will illuminate. 4. Select hot water temperature by pushing button on the controller.
Page 10
Thermann Owner’s Guide Gas Continuous Flow Water Heaters REMOTE CONTROL Priority Control (Change) The temperature can only be controlled by the remote controller which has the priority indication. When the priority button is turned ON, that controller takes priority control over the temperature settings.
FAULT MONITOR When installed with remote controllers the unit has a self diagnosing function for faults. When the unit does not operate correctly an error code is displayed on the remote control TEMPERATURE DISPLAY INDICATOR. The cause of the fault can be determined after checking the fault numbers display on the remote control display.
Thermann Owner’s Guide Gas Continuous Flow Water Heaters WARRANTY This warranty will apply only under all of the following conditions: • The item has been installed by a licensed plumber • Failure is due to a fault in the manufacture of the product •...
Page 13
Up to 200 mg/litre or ppm Warranty Terms Thermann Gas Continuous Flow Hot Water Units are covered by Reece for any cost of labour and parts in the event of a component failure due to any defects that may arise either from workmanship and/or faulty material.
Page 14
Thermann Owner’s Guide Gas Continuous Flow Water Heaters...
Need help?
Do you have a question about the 16NG50-6 and is the answer not in the manual?
Questions and answers