Timer Operation; Test Operation - Haier HSU-30LEA13 - annexe 1 Operation Manual

Operation
HEALTH Operation
The anion generator in the airconditioner can
anion effectively balance the
generate a lot of
quantity of position and anion in
also to kill bacteria and speed up the dust sediment
in the room and finally clean the air in the room.
Healthy Negative ions

TIMER Operation

Set Clock correctly before starting Timer operation
You can let unit start or stop automatically a following times:
Before you wake up in the morning, or get back from outside
or after you fall asleep at night.
POWER/SOFT
TIMER ON-OFF
(3)
POWER/SOFT
POWER/SOFT
To cancel TIMER mode
Just press TIMER button several times untilTIMER mode disappears.
3
the air and
TIMER ON
(1)
POWER/SOFT
(2)TIMER OFF
POWER/SOFT
POWER/SOFT
POWER/SOFT
POWER/SOFT
POWER/SOFT Operation
POWER Operation
(1)
POWER/SOFT
SOFT Operation
(2)
POWER/SOFT
To cancel SOFT operation
Press POWER/SOFT button again ,POWER/SOFT disappears.
For model HSU-24LEB03(T3) and HSU-18LEB03(T3), the indication of POWER/SOFT on
the remote controller disappears 15 minutes after you set the POWER/SOFT function,while
the POWER/SOFT function is still running.
Emergency operation and test operation
Emergency Operation:
Use this operation only when the remote controller
is defective or lost.
When the emergency operation switch is
pressed,the" Pi "sound is heard once, which means
the start of this operation.
In this operation, the system automatically selects
the operation modes,cooling or fan or heat,according
to the room temperature.
Room
Operation
temperature
POWER/SOFT
ABOVE 23 C COOLING
O
BELOW 23 C
O
(Cooling only uint）
Room temperature
BELOW 23
It is not possible to operate in dry mode.

Test operation:

Test operation switch is the same as emergency switch.
Use this switch in the test operation when the room
temperature is below 16
normal operation.
Continue to press the test operation
switch for more than 5 seconds. After
you hear the "Pi" sound twice,release
your finger from the switch: the cooling
operation starts with the air flow speed "Hi".
After 30 minutes, test operation ends automatically.
When you need rapid heating or cooling,
you can use this function.
In COOL mode, fan speed automatically
takes high speed of AUTO fan mode.
In HEAT mode, fan speed automatically
takes medial speed of AUTO fan mode.
To cancel POWER operation
Press POWER/SOFT button twice ,POWER/SOFT disappears.
You can use this function when silence
is needed for rest or reading.
In SOFT operation mode, fan speed
automatically takes low speed of AUTO fan mode.
Timer
Designated
Air flow
mode
mode temperature
NO
26 C
O AUTOMATIC
HEAT AUTOMATIC
23 C NO
O
Timer
Operation Designated
mode
mode temperature
C FAN 26 C
O O
o
C, do not use it in the
Pi
Air flow
NO
AUTOMATIC
Pi Pi