Table of Contents
Advertisement
Parts and Functions
Indoor Unit
Inlet grille
Inlet
Outlet
Anion generator
(inside)
Horizontal flap
(adjust up and down air flow
Don't adjust it manually)
Actual inlet grille may vary from the one shown in the
manual according to the product purchased
Display board
Remote signal receiver
HEALTH display
TIMER OFF display
TIMER ON display
SLEEP display
TEMP display
Outdoor Unit
OUTLET
CONNECTING PIPING AND ELECTRICAL WIRING
DRAIN HOSE
INLET
Clock set
Press CLOCK button, "AM" or "PM" flashes.
Press
or
to set correct time. Each press
or decrease 1min. If the button is kept pressed,time will
change quickly. After time setting is confirmed,press SET,
"AM "and "PM" stop flashing,while clock starts working.
2
Air Purifying Filter
Emergency
Switch
Vertical blade
(adjust left and right air flow)
Display board
AUTO
display
COOL
display
Dry
display
HEAT
display
will increase
POWER/SOFT
Remote controller
19
28
POWER/SOFT
30
1.CODE
Used to select CODE A or
B with a press, A or B will
be displayed on LCD.
Please select A without
special explanation.
2.
RESET button
When the remote
controller appears
abnormal, use a sharp
pointed article to press
this button to reset the
remote controller normal.
3.LIGHT button
Control the lightening and
extinguishing of
the indoor
LED display board.
The following functions and related displays are not
available:
20
26
Loading of the battery
Load the battery,then put on the cover again.
Note:
The distance between the signal transmission head and the rece-
iver hole should be within 7m without any obstacle as well.
When electronic-started type fluorescent lamp or change-over
wireless telephone is installed in the
type fluorescent lamp or
room, the recei
ver is apt to be disturbed in receiving the signals,
so the distance to the indoor unit should be shorter.
Full display or unclear display during operation indicates the
batte
ries have been used up. Please change batteries.
If the remote controller can't run normally during operation, please
reload several minutes later.
remove the batteries and
Hint:
Remove the batteries in case unit won't be in usage for a long period.
If there are any display after taking-out, just need to press reset key.
4. TIMER button
5. CLOCK button
6. HEALTH button
7. MODE button
8. HOUR button
9. SWING button
10. ON/OFF button
11. TIMER ON display
12. FAN SPEED display
LOW
MED
HI
13. LOCK display
14. SWING UP/DOWN display
15. SLEEP display
16. HEALTH display
17. Operation mode display
Operation mode
AUTO
COOL
DRY
Remote controller
18.Singal sending display
19. POWER/SOFT display
20. Left/right air flow display
21. TEMP display
22. TIMER OFF display
23. CLOCK display
24. TEMP button
25. FAN button
26. HEALTH AIRFLOW button
27. SLEEP button
28. SET button
29. POWER/SOFT button
30 . LOCK button
If pressed, the other buttons
will be disabled. Press it once
again,lock will be cancelled.
Remove the battery cover;
Load the batteries as illustrated.
2 R-03 batteries, resetting key
(cylinder);
Be sure that the loading
is in line with the " + "/"-";
AUTO
HEAT
FAN
Advertisement
Table of Contents
