Sloan BASYS EHD-510 Installation Instructions

EHD-510
BASYS Style
®
Hand Dryer Spout
Sloan Valve Company ("Sloan"), warrants its products against defects in materials and workmanship, excluding damage caused by matters beyond Sloan's reasonable
control. Instructions for filing claims can be found in the Limited Warranty which can be obtained at www.sloan.com or by requesting a free copy by telephone at
888.756.2614. Sloan will repair or replace your defective product, or provide a refund, as your exclusive remedy. This is only a general summary of Sloan's Limited
Warranty so it is important to note that the specific terms, conditions, limitations and exclusions, including the duration of warranty coverage for your particular Sloan
product, are contained in the actual Sloan Limited Warranty. The Limited Warranty is subject to applicable laws in your country, state, province or other jurisdiction—
and disputes arising under the Limited Warranty are to be resolved by binding arbitration unless you provide Sloan with an opt-out notice no later than 30 days after
your purchase date. In case of a conflict with this summary, the terms and conditions set forth in the complete Limited Warranty will prevail.
PRIOR TO INSTALLATION
IMPORTANT:
• Turn OFF electrical power to the electrical outlets, then unplug all electrical units prior to installation. Electrical power MUST remain off until installation is
complete.
• Wear proper safety equipment for installation.
• INSTALL ALL PLUMBING IN ACCORDANCE WITH APPLICABLE CODES AND REGULATIONS.
• INSTALL ALL ELECTRICAL WIRING IN ACCORDANCE WITH NATIONAL/LOCAL CODES AND REGULATIONS.
• 120 OR 220 GFI OUTLETS MUST BE USED. VERIFY VOLTAGE REQUIREMENT OF MOTOR ASSEMBLY.
• HAND DRYER FEATURES VARIABLE HEAT AND SPEED CONTROLS AND REQUIRES A MAXIMUM OF 1500 WATTS.
• EACH HAND DRYER MOTOR REQUIRES A DEDICATED 20 AMP GFI CIRCUIT.
• USE APPROPRIATE PRECAUTIONS WHILE CONNECTING THE POWER SOURCE.
TOOLS REQUIRED FOR INSTALLATION
• Assorted Screwdrivers • Drill and Drill Bits • Wrenches • Utility Knife • Wire Cutters
INSTALLATION INSTRUCTIONS FOR
SLOAN HAND DRYERS
NOTE Hand Dryer Spouts for use on AER-DEC
SLOAN LIMITED WARRANTY SUMMARY
®
If you have questions about how to install your hand dryer, call Sloan Technical Support at
1.888.756.2614 or 1.888.SLOAN.14
™ sinks only.
EHD-420
Rush Street Style
®
Hand Dryer Spout
1
Code No: 0816673
Rev. 4 (02/23)
EHD-410
Clark Street Style
®
Hand Dryer Spout