Sears PRO-FORM 730 SIGHT LINE User Manual page 8

DIAGRAM OF THE CONSOLE
Monitor Displays
LED Track
.
Incline Control
Speed Control Pulse Sensor
STEP BY STEP CONSOLE OPERATION
If there is a thin sheet of clear plastic on the face.of the
console, remove it. Next, make sure that the power
cord is properly plugged in (see HOW TO PLUG IN
THE POWER CORD on page 7).
Stand on the foot rails of the treadmill. Find the clip
attached to the key (see the drawing above), and
sUde the clip onto the waistband of your clothing;
..... • .. , - . .
Follow the steps below to operate the console.
i]
Insert the key fully into the power switch.
After a moment, the
four displays and one
indicator in the LED
track will light.
_-J k.__
• POWER v
B
Reset the speed Control.
Slide the speed _) _=-_-I-_.--._-.-_---_'--_-_--_-:==-. vl
control to the . _ .
the RESET : t _=,=, ====.....
q
Each time the
walking belt is "-- "
stopped, the .
speed control must be moved to the RESET po-
sition before the walking belt can be restarted.
,am
Start the walking belt.
Slowly slide the speed control to the right until the
walking belt begins to move at slow speed. Step
onto the walking belt. Change the speed of the
walking belt as desired by sliding the speed control.
To stop the walking belt, step onto the foot rails
and slide the speed control to the RESET posi-
tion. After a few seconds, the displays will pause.