Related Manuals for Alpine Spas Oslo
Summary of Contents for Alpine Spas Oslo
- Page 1 Oslo Sauna Assembly & User Manual 0800 99 33 88 | service@alpinespas.co.nz | www.alpinespas.co.nz 1800 99 33 88 | service@alpinespas.com.au | www.alpinespas.com.au...
-
Page 3: Table Of Contents
CONTENTS Important Safety & Operational Cautions..........Parts Check........................Installation Requirements..................Assembly Instructions .................... Control Panel Operation..................Recommendations for Use................... Cleaning & Maintenance..................Troubleshooting...................... -
Page 4: Important Safety & Operational Cautions
IMPORTANT SAFETY & OPERATIONAL CAUTIONS PLEASE READ ENTIRE MANUAL THROUGH BEFORE PROCEEDING WITH INSTALLATION. SAFETY IMPORTANT SAFETY & OPERATIONAL CAUTIONS 1. Read and follow all instructions carefully. THIS PRODUCT NEEDS TO BE CONNECTED TO AN ELECTRICAL SUPPLY THAT HAS PLEASE READ ENTIRE MANUAL THROUGH BEFORE AN APPROPRIATELY RATED RCD AND INSTALLED ACCORDING TO NATIONAL PROCEEDING WITH INSTALLATION. - Page 5 5. Dry your hands before handling electrical controls. Never unplug the power cord electrical shock exists. 6. DO NOT attempt any repair without consulting Alpine Spas first. Unauthorised repair or adjust the controls with wet hands or when you have wet bare feet. A danger of attempts will void warranty.
-
Page 6: Parts Check
PARTS CHECK This sauna uses pre-installed latches to help piece it together so minimal tools are This sauna uses pre-installed latches to help piece it together so minimal tools are required other than a phillips screwdriver. required other than a phillips screwdriver. Installation Parts Installation Parts Roof Screws: 4pc 4*40mm... -
Page 7: Installation Requirements
INSTALLATION REQUIREMENTS 1. Your sauna can be plugged into a regular house socket but will draw close to 10A. Try to plug into a socket on an electrical circuit that is not shared with other large appliances. 2. Install the sauna on a hard, level surface. 3. - Page 8 ASSEMBLY INSTRUCTIONS Simply place the floor panel on a flat level surface. Place the Bench Seat inside the sauna on the provided supports. Screw the bench seat into the left and right supports using 2x 4*40mm screws. Use two of the 4*40mm screws to screw the bench seat into the side supports in the locations marked above.
- Page 9 Place the back panel up against the rear side of the floor panel. Place the Front Panel onto the sauna and secure with the latches side latches. Latch back wall to side wall.
- Page 10 ASSEMBLY INSTRUCTIONS Place one of the side panels up against the side of the floor panel and latch to the back panel. Place the Bench Seat inside the sauna on the provided supports. Screw the bench seat into the left and right supports using 2x 4*40mm screws. Latch back panel to side panel.
- Page 11 Place the remaining side panel up against the floor panel and latch to the back panel. Place the Front Panel onto the sauna and secure with the latches side latches. Latch back panel to side panel. (Latches on the outside of the sauna.) Latch back wall to side wall.
- Page 12 ASSEMBLY INSTRUCTIONS Slide down the Bench Seat Support panel by lining up its sides with the vertical guides on the inside of the side walls. Make sure the heater grill is Place the Bench Seat inside the sauna on the facing towards the front of the sauna.
- Page 13 Place the Bench Seat inside the sauna on the provided supports, be sure to push the bench seat firmly against the rear wall panel. Screw the bench Place the Front Panel onto the sauna and secure seat into the left and right supports using 2x 4*40mm screws. There are with the latches side latches.
- Page 14 ASSEMBLY INSTRUCTIONS Place the Front Panel onto the sauna and secure with the side latches. Install the Door handle onto the door, using the pre-drilled hole in Place the Bench Seat inside the sauna on the the glass. provided supports. Screw the bench seat into the left and right supports using 2x 4*40mm screws.
- Page 15 Simply lift the Roof Panel onto the top of the sauna. Pass the heater cables through the provided slots before securing the fit. Fix the roof to the side Place the Front Panel onto the sauna and secure panels with the remaining 4*40mm screws. with the latches side latches.
- Page 16 ASSEMBLY INSTRUCTIONS Simply lift the Roof Panel onto the top of the sauna. Pass the heater cables through the provided slots The diagram below shows a breakdown of each wall panel before securing the fit. Fix the roof to the side panels and the respective cables that need to be plugged into the with the remaining 4*40mm screws.
- Page 17 Simply lift the Roof Panel onto the top of the sauna. Pass the heater cables through the provided slots before securing the fit. Fix the roof to the side panels with the remaining 4*40mm screws. Install the door handle by feeding through the threaded screw, adding the washers and Use 4*40mm screws to screw the roof panel into tightening on the two opposite handle pieces.
-
Page 18: Assembly Instructions
ASSEMBLY INSTRUCTIONS Plug the heater panel cables (black plugs) into the Plug in the heater and electrical cables (A, B, C) ASSEMBLY INSTRUCTIONS sockets on the console A B C, in any order. into the control box on top of the sauna roof piece as per diagram below: Plug in the heater and electrical cables (A, B, C) into the control box on top of the sauna roof piece... -
Page 19: Control Panel Operation
CONTROL PANEL OPERATION Overview of Control Panel... - Page 20 CONTROL PANEL OPERATION BASIC OPERATION 1. Powering on Plug the main power cord into the wall outlet. Press the “Power” button once. The control panel should beep and is now operable, but the heaters are not on by default. 2. Turning on the Heaters Press “Power”...
- Page 21 PROGRAMMING THE CONTROL PANEL Temperature Adjustment Temperature can be set between 25 - 70°C. Temperature can be set on the control panel between 20 - 70°C, however the standard average temperature the sauna will reach will Press temp “UP/DOWN ARROWS” to adjust temperature. Temp value be between 50-60°C as heating greatly depends on external ambient will increase or decrease by 1 degree at a time (hold down the buttons temperature.
- Page 22 Heating light ON indicates heating. Once desired temperature is reached, heater will be managed (turned on/off automatically) to maintain the set temperature. Set temp will be stored in memory and CONTROL PANEL OPERATION will be displayed at next startup. Pre-Setting (Turning on the Sauna at a Desired Time) Session Time Adjustment To pre-set a time for the sauna to turn on and start heating follow these Sauna session timer can be set between 0 to 90 minutes.
-
Page 23: Recommendations For Use
RECOMMENDATIONS FOR USE Set up the desired session temperature and time using the control panel. Allow approximately 20-30 minutes for the sauna to warm up before beginning a session. Hydrate yourself. Enjoy the sauna. We recommend a session time of 30-45 minutes. -
Page 24: Cleaning & Maintenance
CLEANING & MAINTENANCE Before using your infrared sauna for the first time, clean the inside of the sauna with a damp cloth. If the smell of the sauna is strong at first, that is normal and please open the door while the sauna is working. The smell will diminish over time. - Page 25 CONTACT INFORMATION If you need assistance, please get in touch via phone or email. service@alpinespas.co.nz 0800 99 33 88 service@alpinespas.com.au 1800 99 33 88 For a digital copy of this guide and also the outdoor sauna user guide visit: http://alpinespas.co.nz/support/ http://alpinespas.com.au/support/...
Need help?
Do you have a question about the Oslo and is the answer not in the manual?
Questions and answers