Operation Mode - Haier HSU-09HEK03-R2 Operating Manual

Operation
Comfortable SLEEP
Operation
Before going to bed, you can simply press the
SLEEP button and unit will operate in SLEEP
mode and bring you a sound sleep.
Use of SLEEP function
After the unit starts, set the operation status,
then press SLEEP button before which the
clock must be adjusted and time being set.

Operation Mode

1. In COOL,DRY mode
1 hours after SLEEP mode starts, temp. will
become 1 C higher than temp. setting. After
O
another 1 hours, temp. rises by 1
The unit will run for further 6 hours then stops.
Temp. is higher than temp. setting so that room
temperature won't be too Iow for your sleep.
SLEEP operation starts
1 hr
Rises 1
1 hr
Temp.setting
In COOL, DRY mode
ON/OFF
FAN
MODE
SWING
TIMER
CLOCK
SET
SLEEP
LOCK
RESET
C further.
O
SLEEP operation stops
Approx.6hrs
Rises 1 C
O
C
O
Unit stop
2. In HEAT mode
1 hours after SLEEP mode starts, temp will
become 2 C lower than temp.setting. After
O
another 1 hours, temp decrease by 2 C
further. After more another 3 hours, temp.
rises by 1 C further. The unit will run for
O
further 3 hours then stops. Temp. is lower
than temp. setting so that room temperature
won't be too high for your sleep.
Temp.setting
1 hr
Decreases 2
1 hr
SLEEP
operation starts
In HEAT mode
3. In AUTO mode
The unit operates in corresponding sleep
mode adapted to the automatically selected
operation mode.
4. In FAN mode
It has no SLEEP function.
5.
When quiet sleeping function is set to 8 hours,
the quiet sleeping time can not be adjusted.
When TIMER function is set , the quiet sleeping
function can't be set up .After the sleeping function
is set up,if user resets TIMER function, the sleeping
function will be cancelled; the machine will be in the
state of timing-on,if the two modes are set up at the
same time ,either of their operation time is ended
first ,the unit will stop automatically,and the other
mode will be cancelled.
Power Failure Resume Function
If the unit is started for the first time, the
compressor will not start running unless 3
minutes have elapsed. When the power
resumes after power failure, the unit will run
automatically, and 3 minutes later the
compressor starts running.
Note to the power failure resume:
press the sleep button ten times in five seconds
and enter this function after hearing four sounds.
And press the sleep button ten times within five
seconds and leave this function after hearing
two sounds.
12
O
Unit stop
C
O
Decreases 2 C
O
3 hrs
3 hrs Rises 1 C
O
SLEEP
operation stops