Auto,Cool, Dry,Heat And Fan Operation - Haier HSU-09HEK03-R2 Operating Manual

Room air conditioner wall mounted type
Hide thumbs Also See for HSU-09HEK03-R2:
Table of Contents

Advertisement

Operation
Auto,Cool, Dry,Heat and Fan operation
(1) Unit start
Press ON/OFF button, unit starts.
(2) Select operation mode
Press MODE button. For each press, operation
mode changes as follows:
Remote controller:
Unit will run in selected mode.
(3) Select temp. setting
Press TEMP button.
Every time the button is pressed, temp. setting increases 1
Every time the button is pressed, temp. setting decreases 1
Unit will start running to reach the temp. setting on LCD.
(4) FAN
Press FAN button. For each press, fan speed changes
as follows:
AUTO
Unit will run at selected fan speed.
Note:AUTO is not available in FAN mode.
(5) Unit stop
Press ON/OFF button.
Note:
1.
When FAN is set to AUTO, the air conditioner automatically adjusts the fan speed according
to room temperature.
2.In DRY mode, when room temperature becomes lower than temp.setting+2
unit will run intermittently at LOW speed regardless of FAN setting.
In FAN operation mode, the unit will not operate in COOL mode but only in FAN mode ,
3.
AUTO is not available in FAN mode.And temp.setting is disabled.
In FAN mode,SLEEP operation is not available.
4.
In HE AT mode, warm air will blow out after a short period of the time due to cold-draft
prevention function.When FAN is set to AUTO, the air conditioner automatically adjusts
the fan speed according to room temperature.
5.
Remote controller can memorize each operation status. When starting it next time,
just press ON/OFF button and unit will run in previous status.
AUTO
COOL
DRY
LO
MED
FAN
HEAT
HI
8
ON/OFF
1
5
FAN
4
MODE
3
2
SWING
TIMER
CLOCK
o
C
SET
SLEEP
o
C
LOCK
RESET
o
C,
3

Advertisement

Table of Contents
loading

This manual is also suitable for:

Hsu-09hek103/r2 - annexe 1Hsu-12hek03/r2

Table of Contents