Cool Operation - Haier HSU-09H03/R - annexe 2 Operation Manual

Operation
Display board
Remote controller
PURIFY
FRESH
HUMIDITY
POWER/SOFT
TEMP./HUMIDITY DISPLAY
1. Unit start
Press ON/OFF on the remote controller, unit starts.
2.Select operation mode
Press MODE button. For each press, operation mode
changes as follows:
Remote controller:
Then Select COOL operation
3.Select temp.setting
Press TEMP. button
Every time the button is pressed, temp.setting
o
increase 1 C,if kept depressed, it will increase
rapidly
Every time the button is pressed, temp.setting
o
decrease 1 C,if kept depressed, it will decrease
rapidly
Select a desired temperature.
4.Fan speed selection
Press FAN button. For each press, fan speed changes as
follows:
Remote controller:
Air conditioner is running under displayed fan speed.
When FAN is set to AUTO, the air conditioner
automatically adjusts the fan speed according to room
temperature.
5.Unit stop
Press ON/OFF button, the unit stops.

Cool Operation

AUTO COOL DRY FAN
LOW
HI
MED
HEAT
AUTO