Clock Set - Haier HSM09HEK03/R2 - annexe 1 Operating Manual

Parts and Functions
Operation
1
2
5
3
ON/OFF
13
FAN
18
MODE
SWING
POWER/SOFT
TIMER
12
21
CLOCK
LIGHT
19
SET SLEEP
17
LOCK RESET
1. Mode display
AUTO
COOL
DRY
HEAT
FAN
2. SWING display
3. FAN SPEED display

Clock set

When unit is started for the first time and after replacing batteries in remote controller,
clock should be adjusted as follows:
Press CLOCK button, "AM" or "PM" flashes.
Press or to set correct time. Each press will increase or decrease 1min. If the
button is kept depressed, time will change quickly.
After time setting is confirmed, press SET, "AM "and "PM" stop flashing, while clock
starts working.
NOTE: Cooling only unit do not have displays and functions related with heating
Hints
After replacing with new batteries, remote controller will conduct self-check, displaying
all information on LCD. Then, it will become normal.
Buttons and display of the remote controller.
10
6
7
8
9
4
11
15
23
20
14
16
22
AUTO LO MED HI
6
4. SLEEP display
5. LOCK display
6. SIGNAL SENDING
7. TIMER OFF display
8. TIMER ON display
9. CLOCK display
10. TEMP display
11. POWER ON/OFF
Used for unit start and stop.
12. MODE
Used to select AUTO run, COOL, DRY，
and FAN operation
HEAT
13. FAN
Used to select fan speed LO, MED, HI, AUTO
14. HOUR
Used to set clock and timer setting.
15. SWING
Used to set auto fan direction.
16. SLEEP
Used to select sleep mode.
17. LOCK
Used to lock buttons and LCD
display.
18. TEMP.SETTING
Used to select your desired temp.
19. SET / LIGHT
Used to confirm timer and clock settings.
Control the lightening and extinguishing of
the indoor LED display board.
20. TIMER
Used to select TIMER ON, TIMER OFF,
TIMER ON-OFF
21. CLOCK
Used to set correct time
22. RESET
Used to reset the controller back to
normal condition.
23. HOUR / POWER/SOFT
Used to set clock and timer setting.
Every time the button is pressed,display changes
as follows:
POWER
BLANK
SOFT