Display Codes - Haier HMS-1250 Manual

18

DISPLAY CODES

DISPLAY CODES AND SPECIAL FUNCTIONS
CODES CAUSES
Err1 ¬ Door is not properly shut.
Err2 ¬ Drainage error, water not emptied within 4
minutes.
Err3 ¬ Temperature sensor not properly connected or
damaged.
Err4 ¬ Heater error (Appears at the end of a cycle).
Err5 ¬Water level not met in 8 minutes.
¬The height of the drain hose is below 80 cm.
¬ The drain hose is in water.
Err7 ¬ Motor overheat protection or damage.
Err8 ¬ Water exceeds protective level.
End ¬ End of wash cycle.
1:25 ¬The remaining time is 1 hour 25 minutes.
¬ Control panel lock function: Press the "Delay" and the "Temperature" buttons simultaneously for 3 seconds after starting a program.
It can no longer be changed by operating buttons or knobs. To unlock press the "Delay" and "Start/Pause" buttons again for 3
seconds.
¬ Power-off memory function: In case of abrupt power failure or the need to cut off the power during a program cycle, the present
settings will be saved and the preset operation will resume when the power is on again.
¬ To cancel a program
Press the "Start/Pause" button, then switch off the power and the program is automatically cancelled. Turn the program selector
again to choose another program.
MAINTENANCE
SOLUTIONS
_ Shut the door properly.
_ Clean the fi lter and check the drain hose for blockage. If error
still exists, please contact the maintenance personnel.
_ Contact the maintenance personnel.
_ Reduce load and then start washing again. If problem still
exists, please contact the maintenance personnel.
_ Make sure that tap is turned on, and water pressure is normal.
If problem still exists, please contact the maintenance personnel.
_ Install drain hose within 80-100 cm of height.
_ Make sure the drain hose is not in water.
_ Contact the maintenance personnel.
_ Contact the maintenance personnel.