Pentair Everpure 2FC-S Installation Instructions

INSTALLATION INSTRUCTIONS
Please read carefully and retain for future reference.
CONTENTS
1. IMPORTANT: Before You Begin
2. Included Parts
3. Plumbing In Your System
4. Warranty Information
1. IMPORTANT: Before You Begin
Please read this document carefully and retain it for future reference.
For the correct operation of this appliance, it is essential to strictly observe this installation and
�
operating instruction.
Do not use this product with water that is microbiologically unsafe or water of unknown quality
�
without adequate disinfection before or after this system.
Installation must comply with any existing State or Local Plumbing codes. Some Plumbing Codes
�
require the installation of water filter systems to be carried out by a licensed plumber.
For COLD water use only. Maximum temperature 38°C. Minimum temperature 2°C.
�
For internal use only.
�
The inlet water pressure to this water filter housing must not exceed 900kPa (130psi).
�
A certified pressure limiting valve not exceeding 650kPa (95psi), dual check backflow prevention
�
valve must be installed on the inlet line immediately preceding this water filter housing. This valves
i ncluded with this system (see Item 10 in Parts Section).
We also recommend the installation of a water hammer protection device to protect the water
�
filter housing and its installation. Where water hammer problems exist, a water hammer protection
device must be installed. Symptoms of water hammer can be noisy, shuttering, and banging
pipes when water-consuming appliances are operating or taps are turned off. Should the system
not be used for 2 days or more, flush 1-2 liters of water through the system before consuming the
water.
To ensure the high level of performance and protection provided by this water filter system, only
�
use Bombora replacement cartridges which have a maximum cartridge life of 12 months.
bomborasupplies.com.au
BSSF to 2FCS-UPGRADE KIT
1300 724 249 sales@bomborasupplies.com.au