Related Manuals for Pentair EVERPURE EZ-RO 200/2G-BL
Summary of Contents for Pentair EVERPURE EZ-RO 200/2G-BL
- Page 1 EZ-RO SYSTEMS INSTALLATION & OPERATION GUIDE For Reverse Osmosis Systems with Blending & Hydropneumatic Tanks foodservice.pentair.com...
-
Page 2: Table Of Contents
System Startup and Flushing Process ........ 11 INTRODUCTION Leveraging proprietary technology, the Pentair® Everpure® EZ-RO system provides high quality water for applications, such as premium espresso, coffee, ice, and blended beverages. The system combines multiple water treatment technologies, providing superior protection against taste and odor-causing contaminants. The system meets espresso, coffee, ice, and... -
Page 3: General Information
Membrane Filter The Pentair EZ-RO system includes all the necessary fittings for installation except for an air gap for the waste water. Lengths of 1/4", 3/8", and 1/2" tubing have been provided. The Pentair EZ-RO system is packaged as a complete unit in two cartons. You should have the following:... -
Page 4: Installation Requirements
A 1/2" or larger inside diameter Silica <20 mg/l tubing or hose will minimize pressure drop. 6 | PENTAIR EZ-RO INSTALLATION AND OPERATION GUIDE FOODSERVICE.PENTAIR.COM PENTAIR EZ-RO INSTALLATION AND OPERATION GUIDE FOODSERVICE.PENTAIR.COM | 7 Proof April 18, 2022... -
Page 5: Wall-Mount Installation
Make sure O-rings are in correct location in fitting. Insert tubing past both O-rings until it comes to a hard stop. 8 | PENTAIR EZ-RO INSTALLATION AND OPERATION GUIDE FOODSERVICE.PENTAIR.COM PENTAIR EZ-RO INSTALLATION AND OPERATION GUIDE FOODSERVICE.PENTAIR.COM | 9... -
Page 6: Reject Flow Restrictor Chart
NSF testing completed at influent water conditions of 750 PPM TDS and at 50 PSI water, using reject flow restrictor as indicated. Inlet valve: top black handle pointed down (open). Outlet valve: bottom black handle pointed to right (closed). 10 | PENTAIR EZ-RO INSTALLATION AND OPERATION GUIDE FOODSERVICE.PENTAIR.COM PENTAIR EZ-RO INSTALLATION AND OPERATION GUIDE FOODSERVICE.PENTAIR.COM | 11... -
Page 7: Pre-Filter And Mineral Addition Flush And Tank Fill
20. Pressure should drop to 0 psi. IMPORTANT: Bring pressure down to 0 psi before attempting filter changes. 19 19 12 | PENTAIR EZ-RO INSTALLATION AND OPERATION GUIDE FOODSERVICE.PENTAIR.COM PENTAIR EZ-RO INSTALLATION AND OPERATION GUIDE FOODSERVICE.PENTAIR.COM | 13 Proof April 18, 2022... -
Page 8: System Dump And Fill, Connect To Equipment
RO water distribution piping. The size of the blended water tubing/piping should be 1/2- inch (12.7 mm) O.D. minimum. 14 | PENTAIR EZ-RO INSTALLATION AND OPERATION GUIDE FOODSERVICE.PENTAIR.COM PENTAIR EZ-RO INSTALLATION AND OPERATION GUIDE FOODSERVICE.PENTAIR.COM | 15... -
Page 9: Filter Change And Flushing Procedure
• Water will run from the reject line and tank sampling valve. 12. Flush pre-filter and mineral cartridge for 10 minutes or until water runs clear. 16 | PENTAIR EZ-RO INSTALLATION AND OPERATION GUIDE FOODSERVICE.PENTAIR.COM PENTAIR EZ-RO INSTALLATION AND OPERATION GUIDE FOODSERVICE.PENTAIR.COM | 17... - Page 10 However, you may need to recalibrate based on your needs, as well as from time-to-time to ensure best results. 18 | PENTAIR EZ-RO INSTALLATION AND OPERATION GUIDE FOODSERVICE.PENTAIR.COM PENTAIR EZ-RO INSTALLATION AND OPERATION GUIDE FOODSERVICE.PENTAIR.COM | 19...
-
Page 11: Tds Monitor
Membrane failure Measure TDS out of permeate sample port. Measure reject flow rate. Replace Tel: 800.942.1153 (US Only) • 630.307.3000 Main • Email: servicespecialist@pentair.com prefilter and RO membrane as needed. Check to see if the capillary flow control is plugged. Replace capillary flow control as needed. -
Page 12: Replacement Parts
DIMENSIONS 8.0" REPLACEMENT PARTS 18.0" Contact your local Pentair® Everpure® distributor for system replacement parts. To locate your distributor, call customer Wall Mounted Processor Processor on Optional Stand service at 800.942.1153 or 630.307.3000. 18.0" 18.0" CANISTERS OPTIONAL STAND KIT PART EV315928... -
Page 13: Plumbing Flow
Southeast Asia | 390 Havelock Road, | #04-01 King’s Centre | Singapore 169662 | 65.6768.5800 Tel | cseverpure@pentair.com All indicated Pentair trademarks and logos are property of Pentair. Third party registered and unregistered trademarks and logos are the property of their respective owners.
Need help?
Do you have a question about the EVERPURE EZ-RO 200/2G-BL and is the answer not in the manual?
Questions and answers