Haier HDC1804TW - 07-09 User Manual page 17

English
2) Press the door release button to open the door.
3) Check to make sure that the interior bottom filter is in the right position
and clean.
4) Place the dishes on the dish rack and cutlery inside the cutlery basket.
5) Check to make sure that the rotating spray arm can turn freely all the
way round. If necessary remove any obstacles.
6) Fill the detergent in the recessed area on inner door panel .
Approximately 1/2 Oz ( about 12 grams) could be added for a
normal cycle.
7) Close the door until you hear a 'click' sound.
8) Open the water supply by using the faucet.
9) Press the power (ON/OFF) button and power light should illuminate.
10) Press the button in then power light will light on to select the washing
cycle.
• Select the desired wash cycle by pressing the program button.
Heavy
The program indicator light will come on. The appliance will run about 3
seconds thereafter and the program light will flash during all cycles.
NOTE: At the beginning of each cycle, the dishwasher always starts in
the "drain" mode. This is because the drain pump always retains a small
amount of water (in the sump) from the previous cycle. This is necessary
to keep the pump primed. Therefore, do not be alarmed if you see a
small amount of water being pumped out from the drain hose prior to the
start of the regular wash cycle. This is normal.
16
Power and cycle
indicator lights
cycle selection button
Normal Gentle