Advertisement
English
Checking water temperature
• The minimum incoming temperature must be at 120˚F/49˚C in order
for the detergent to dissolve properly.
If you are unsure of the temperature of your hot water:
1. Open the hot water faucet and let it run for a minute and fill a glass.
2. Take a thermometer and check the temperature of the water.
3. If the temperature is below the recommended 120˚F / 49˚C, then
you need to adjust the water temperature on your water heater in
order to maintain that temperature level.
Overflowing protection
• In case the water level is rising above the highest acceptable point,
the security pressure switch will activate the drain pump
automatically.
Cycle selection chart
Turn the cycle control knob to the desired cycle. If the door is properly
closed the cycle will start.
Turn the cycle knob to rinse and hold to use this feature. DO NOT
activate the heated dry option while using this feature. Do not use
detergent in this cycle.
Pre-wash
pots &
pans
heavy wash
normal
wash
rinse & hold
* Small amounts of water run through the pump to remove soil particles.
• Shows what steps are there in each cycle. Cycle time includes dry time.
Cycle time may be longer depending on the temperature of the water
entering the dishwasher.
Note: Cooler the water, longer the cycle time.
15
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Advertisement
