Important Safety Message For Draft Beer Dispensing - Haier HBF205E - 04-06 User Manual

English
Carefully tilt the two beer kegs combination and rest the edge on the stainless
steel keg floor support on the bottom of the interior cabinet. Slide the kegs in
slowly, ensuring that it is properly located.
COMPLETE
Note: If only one keg is to be dispensed you must still complete all the above
steps. Simply leave one keg coupler disconnected in the upright / locked
position. Please make sure that the black shut off valves are on the C02
regulator are in the off position.
When stacking 2 kegs be certain to securely install the included keg
joining bracket with the supplied hardware.
Make sure the hoses are not damaged by the kegs.
Wing Nut
Retainer
Screw
C02 Retainer
Important Safety
Message for Draft
Beer Dispensing
When CO is used for
2
draft beer dispensing, the system must be adequately
protected against excessive pressure build-up. This is accomplished by the
already installed two safety devices with adequate relief capacity in the system.
Safety devices are installed in the following places:
A. On or immediately downstream from the CO
B. On the keg coupler.
11
Fixing Screws
THIS MAY REQUIRE 2 PEOPLE TO
Beer Keg
Keg Support
regulator.
2
Lift Upright