Care And Cleaning - Haier GDZ3.5-1-HK User Manual

Care and Cleaning

Clean the buildup such as lints on filters in time after each use, otherwise it will affect
the performance of your dryer.
Please unplug the power cord first when cleaning it.
Cleaning of filters
The lint filter must be used for drying.
It must be cleaned in time after each use.
1. Remove the filters
Remove by pulling straight up with hands inserted
into the four holes around the exhaust vent shroud
in the sequence of "Exhaust vent shroud - Lint filter -
Exhaust filter", as shown in figure 1.
2. Clean the lints
Separate "exhaust vent shroud","lint filter" and "exhaust
filter" and clean the lints on the filter and exhaust filter
with a soft brush or vacuum cleaner.
Do not damage the filters (as shown in figure 2)
3. Install the filters
After cleaning, assemble in the sequence of "exhaust filter
-filter-exhaust vent shroud",align the recesses in the center
of filter with the projection in the center of drum and make
sure that it is firmly inserted (as shown in figure 3).
Note:The filter fixed in the bottom of the drum shall also
be cleaned with a soft brush.
Cleaning of the air intake filter
The filter shall be cleaned approximately every month.
Remove by pulling outwards with holding the upper and
lower ends of the air intake shroud. Remove the filter
inside the shroud and clean it with a soft brush or cleaner.
Reassemble and install it back as before.
Slightly push upwards
with your thumb until
latch hook disconnected
and take it out.
Air Intake Shroud
Air Intake Filter
Exhaust
Lint
vent shroud
filter
Lints
Lint Filter
Cleaning of Housing
Clean the interior drum or dryer housing,
with wet soft cloth, if stained.
Do not wash directly with water.
Clean it with neutral detergent.
Do not use thinner,gasolene or alcohol.
Air Intake Filter
Figure 1
Exhaust
Filter
Exhaust Filter
Dust Cleaner
Figure 2
Figure 3