JSP FORCE 10 TYPHOON BPB003-04-000 Series Technical Specification

FORCE™
TWIN CARTRIDGE FULL FACE RESPIRATOR
PRODUCT CODE: BPB003-_04-000
ONE OF THE LIGHTEST, MOST WELL BALANCED CLASS 1 FULL FACE MASKS AVAILABLE
INSTRUCTIONS FOR USE
Fully loosen all four head straps, then place the harness at back of
head and position facepiece over the face
Pull the ends of the four straps to adjust tightness, starting with
the neck straps first, then the forehead straps. Do not over tighten
the head straps
Perform a positive/or negative pressure fit check each time the
respirator is donned
ORINASAL:
Thermoplastic Elastomer and
polypropylene
CLEANING & MAINTENANCE
Disassemble by removing the filters
The centre adapter, lens and faceseal can also be removed if
necessary
Clean and sanitise the facepiece (excluding cartridges and filters)
by immersing in warm cleaning solution and scrub with soft brush
until clean. Parts may also be cleaned in a washer
Disinfect respirator by soaking in a solution of quaternary
ammonium disinfectant or sodium hypochlorite (50ppm chlorine)
Rinse in fresh, warm water and air dry in a non-contaminated
atmosphere. Drying temperatures must not exceed 50°C
Respirator components, especially exhalation valve and seat,
should be inspected prior to each use. Any damaged or deteriorated
components should be replaced
The cleaned respirator should be stored at ambient temperature in
a dry non-contaminated atmosphere
DISCLAIMER: Information presented within this technical specification was correct on date of issue. Information may be subject to change
without notice as part of ongoing product improvement and development. To confirm any specific piece of information shown is current
please email technical@jsp.co.uk.
MANUFACTURING FOR SAFETY
WWW.JSP.CO.UK
TYPHOON™
LENS:
Polycarbonate. Panoramic
Anti-Scratch design
UKSALES@JSP.CO.UK
TEL: +44 (0)1993 826050
TYPHOOON EXHALATION
VALVE:
Polycarbonate valve casing and
silicon diaphram
CONFORMITY
Tested to the relevant European Standards (EN136 (Class 1),
EN143, EN14387) and have met the requirements shown below:
Facepiece EN136
Gas Filter Performance EN14387
Particulate Filter Performance EN143
Flammability EN136
EC Type Examination Certificate number 683396
TECHNICAL
SPECIFICATION
RESPIRATORY PROTECTION
HEAD HARNESS:
Thermoplastic Elastomer harness
and ABS Buckles
Issued 01/10/18, V4
CUTOUT