Opening The Transportation Locks; Connecting To The Drain; Adjusting The Feet; Connecting To The Water Supply - Beko WML 15065 D Manual

2 Installation
Removing packaging
reinforcement
Tilt the machine to remove the packaging
reinforcement. Remove the packaging
reinforcement by pulling the ribbon.

Opening the transportation locks

A Transportation safety bolts must
be removed before operating the
washing machine! Otherwise, the
machine will be damaged!
1. Loosen all the bolts with a spanner
until they rotate freely ("C")
2. Remove transportation safety bolts
by turning them gently.
3. Fit the covers (supplied in the bag
with the Operation Manual) into the
holes on the rear panel. ("P")
C Keep the transportation safety bolts
in a safe place to reuse when the
washing machine needs to be moved
again in the future.
C Never move the appliance without
the transportation safety bolts
properly fixed in place!

Adjusting the feet

A Do not use any tools to loosen the
lock nuts. Otherwise, they can be
damaged.
1. Manually (by hand) loosen the lock
nuts on the feet.
2. Adjust them until the machine stands
level and firmly.
3. Important: Tighten all lock nuts up
again.

Connecting to the water supply.

Important:
• The water supply pressure required
to run the machine must be 1-10 bar
(0,1 – 1 MPa).
• Connect the special hoses supplied
with the machine to the water intake
valves on the machine.
• In order to prevent water leakage that
may occur at the connection points,
there are rubber seals (4 seals for the
models with double water inlet and
2 seals for other models) attached
to the hoses. These seals should
be used at the tap and machine
connection ends of the hoses. The
plain end of the hose fitted with a
filter must be attached to the tap and
the elbowed end must be attached
to the machine. Tighten the nuts of
the hose well by hand; never use
wrenches to tighten the nuts.
• Models with a single water inlet
should not be connected to the hot
water tap.
When returning the appliance to its place
after maintenance or cleaning, care should
be taken not to fold, squeeze or block the
hoses.

Connecting to the drain

The water discharge hose can be attached
to the edge of a washbasin or bathtub. The
drain hose should be firmly fitted into the
drain as to not get out of its housing.
Important:
• The end of the drain hose must be
directly connected to the wastewater
drain or to the washbasin.
• The hose should be attached to a
height of at least 40 cm, and 100 cm
at most.
• In case the hose is elevated after
laying it on the floor level or close
to the ground (less than 40 cm
above the ground), water discharge
becomes more difficult and the
laundry may come out wet.
• The hose should be pushed into the
drainage for more than 15 cm. If it is
too long you may have it shortened.
3 - EN