Installation Removing Packaging Reinforcement; Opening The Transportation Locks; Connecting To The Drain; Adjusting The Feet - Beko WMD 65105 Manual

2 Installation
Removing packaging
reinforcement
Tilt the machine to remove the packaging
reinforcement. Remove the packaging
reinforcement by pulling the ribbon.

Opening the transportation locks

A
Transportation safety bolts must be
removed before operating the washing
machine! Otherwise, the machine will be
damaged!
1. Loosen all the bolts with a spanner until
they rotate freely ("C")
2. Remove transportation safety bolts by
turning them gently.
3. Fit the covers (supplied in the bag with the
Operation Manual) into the holes on the
rear panel. ("P")
C
Keep the transportation safety bolts in
a safe place to reuse when the washing
machine needs to be moved again in the
future.
C
Never move the appliance without the
transportation safety bolts properly fixed in
place!

Adjusting the feet

A
Do not use any tools to loosen the lock
nuts. Otherwise, they can be damaged.
1. Manually (by hand) loosen the lock nuts on
the feet.
2. Adjust them until the machine stands level
and firmly.
3. Important: Tighten all lock nuts up again.

Connecting to the water supply.

Important:
• The water supply pressure required to run
the machine must be 1-10 bar (0,1 – 1
MPa). (Practically, it is necessary to have
10 – 80 liters of water flowing from the tap
in one minute to have your machine run
smoothly.)
• Connect the special hoses supplied with
the machine to the water intake valves on
the machine.
• In order to prevent water leakage that may
occur at the connection points, there are
rubber seals (4 seals for the models with
double water inlet and 2 seals for other
models) attached to the hoses. These seals
should be used at the tap and machine
connection ends of the hoses. The plain
end of the hose fitted with a filter must be
attached to the tap and the elbowed end
must be attached to the machine. Tighten
the nuts of the hose well by hand; never
use wrenches to tighten the nuts.
• Models with a single water inlet should not
be connected to the hot water tap.
When returning the appliance to its place after
maintenance or cleaning, care should be taken
not to fold, squeeze or block the hoses.

Connecting to the drain

The water discharge hose can be attached to
the edge of a washbasin or bathtub. The drain
hose should be firmly fitted into the drain as to
not get out of its housing.
Important:
• The end of the drain hose must be directly
connected to the wastewater drain or to
the washbasin.
• The hose should be attached to a height of
at least 40 cm, and 100 cm at most.
• In case the hose is elevated after laying it
on the floor level or close to the ground
(less than 40 cm above the ground), water
discharge becomes more difficult and the
laundry may come out wet.
3 - EN